Table of Contents
Advertisement
Available languages
Available languages
INSTALLATION INSTRUCTIONS
BEFORE INSTALLATION
WARNING: RISK OF ELECTRIC SHOCK! Ensure the electricity
to the wires you are working on is shut off. Either remove the
fuse or turn off the circuit breaker before removing the existing
bath fan or installing the new one.
1. Remove existing fan.
If you are not replacing an existing fan, skip to step 3.
2. Measure the opening to ensure it is large enough to
accommodate the 9-1/4 in. x 9-1/4 in. dimensions of the new
fan housing (A).
3. If this fan is not replacing an old fan be sure to cut a
9-3/8 in. x 9-3/8 in. opening for the fan housing (A).
For spacing of 15 in. to 23-1/2 in. between ceiling joists:
4. Insert suspension bracket (C) into the tabs on the duct side
of the fan housing (A). Insert suspension bracket (D) into the
tabs on the opposite side of the fan housing (A) and then slide
suspension bracket (E) into suspension bracket (D).
1
2
3
4
E
6
C
D
Homewerks.com
Hide quick links:
Advertisement
Chapters
Table of Contents
Need help?
Do you have a question about the 7130-16-BT and is the answer not in the manual?
Questions and answers
I need to know how to clean the tube that the light is in it has bugs in it.
The manual does not specifically mention cleaning the light tube. However, to clean the grille and surrounding areas, follow these steps:
1. Turn off the power and disconnect the circuit breaker or remove the fuse.
2. Squeeze the mounting springs and pull the grille down.
3. Disconnect the grille from the fan housing by unlocking the small gray and black connectors.
4. Clean the grille with a damp cloth.
5. Use a vacuum to remove dust and debris from the fan housing.
6. Wipe the fan housing with a damp cloth and dry it.
If the bugs are inside the light cover and it is not removable per the manual, contact customer service for further guidance.
This answer is automatically generated
Light blinks, nothing works
The Homewerks 7130-16-BT light may be blinking and not working due to a power reset issue. To resolve this, turn off the power for 5 seconds, then reconnect the grille and test. Repeat as necessary. If the issue persists, check the wiring, ensuring the house neutral wire is properly connected to the switch neutral wire and the fan neutral wire. The switch requires a dedicated neutral wire connection; if it is missing, a qualified electrician must install one.
This answer is automatically generated