Maintenance - Husqvarna BV 30 Operator's Manual

To operate the product
1. Spray the lowest part of the beam with concrete form
oil or concrete release agent. This makes it easier to
clean the product after operation because the
concrete does not attach to the beam.
2. Put the beam at the start of the first section of the
concrete surface.
3. Start the product.
4. Move the throttle control to adjust the vibration
frequency.
5. Hold the handles tightly with two hands.
6. Walk slowly rearward and at the same time lift the
product until the rear edge of the beam is slightly
lifted. The vibrations remove your shoe prints from
the concrete surface.
7. Put 30-35 cm/11.8-13.8 in. of the beam on the
smooth concrete surface to make an overlap on the
next section of the concrete surface.
8. To make areas of concrete level, do the procedure
that follows.
a) In the 4 corners, make 30-45 cm/11.8-17.7 in.
diameter of wet concrete areas (A) with a hand
float. Use a laser to make sure that the wet
concrete areas have the correct level. The
distance between the outer edges of the wet
concrete areas must not be more than the length
of the beam.
A
Introduction
WARNING: Read and understand the safety
chapter before you do maintenance on the
product.

Maintenance

Clean the product.
10
To stop the product
1. Move the throttle control to the idle speed position.
2. Push the stop button for the engine. Refer to
3. Move the fuel valve to the "OFF" position.
Maintenance
Maintenance schedule
* = General maintenance done by the operator. The
instructions are not given in this operator's manual.
X = The instructions are given in this operator's manual.
O = Refer to the engine manual for instructions.
After the
Each use
first 10h
X
b) Operate the product between the wet concrete
areas to make 2 parallel strips (B). The strips
must be 30-45 cm/11.8-17.7 in. wide.
B
c) Put the end of the beam on each of the parallel
strips and operate the product (C). Make sure
that the beam follows the contour of the parallel
strips.
C
overview on page 2 .
Each 25h Each 50h
Product
Each 2
Yearly or
years or
each 100h
each 300h
1294 - 004 - 01.12.2021