JVC RA-E211B Instruction Manual page 3

INTRODUCTION
• Thank you for buying our product.
• Please read through these operating instructions, so you will know how to
operate your equipment properly. After you finished reading the instructions
manual, put it away in a safe place for future reference.
WARNINGS
• Do not attempt to disassemble or alter any part of the equipment that is not
expressly described in this guide. Disassembly or alteration may result in
high-voltage electrical shock. Internal inspections, alterations and repairs
should be conducted by qualified service personnel only.
• Ensure minimum distances of 5cm around the apparatus for sufficient venti-
lation. Do not place the product in closed bookcases or racks without proper
ventilation. Ensure that the ventilation is not impeded by covering the ventila-
tion openings with items, such as newspapers, table-cloths, curtains, etc.
• No naked flame sources, such as lighted candles, should be placed on the
apparatus.
• It shall not be exposed to dripping or splashing and that no objects filled with
liquids, such as vases, shall be placed on the apparatus.
• Use of power sources, or batteries not expressly recommended for this equip-
ment may lead to overheating, malfunction of the equipment, fire, electrical
shock or other hazards. Use only the recommended power source.
• Do not use or store the equipment in humid or dusty area. Attention should be
drawn to the use of apparatus in tropical and/ or moderate climates.
• Danger of explosion if battery is incorrectly replaced. Replace only with the
same or equivalent type. Batteries shall not be exposed to excessive heat
such as sunshine, fire or the like. Never throw batteries in fire! Attention
should be drawn to the environmental aspects of battery disposal.
• Where the mains plug or an appliance coupler is used as the disconnect
device, the disconnect device shall remain readily operable.
• Marking plate is located at bottom enclosure of the apparatus.
• Never place the projector clock close to electric motors or other equipment
generating strong electromagnetic fields. Exposure to strong magnetic fields
may cause malfunctions or corrupt image.
• Do not place projector clock on places sensitive to vibrations or table edges.
• Do not look directly into the projector lens as doing this may permanently
damage your sight.
EN