Table of Contents
Advertisement
All manuals and user guides at all-guides.com
Introduction
Rear Panel
LAN Port
Use standard LAN cables (RJ45 connectors) to connect your PCs to
these ports.
RESET
Click this button to setup WPS Auto mode and pin mode, or reset all
setting to factory default. After Reset switch is pressed, system will take
following actions:
•
Press once (less than 3 seconds) under Wireless connection, system
will be in WPS PBC model (Auto mode).
•
Press and hold over 3 seconds (less than 10 seconds) under Wire-
less connection, system will be in WPS PIN code mode (8 digital,
generated from last 3 byte of MAC address)
•
Press and hold over 10 seconds, reset to manufacturer default value
and reboot.
POWER Switch
Push the button down to power on the device
Power Port
Connect the supplied power adapter here.
3
Advertisement
Table of Contents
