Installing Mounting Plate On An S7-300 Standard Rail - Siemens SIMATIC NET SCALANCE W786 Series Operating Instructions Manual

To screw the cover plate for the cable feedthrough to the mounting plate, follow the steps below:
1. Fit the cover plate on the mounting plate from below until the two lugs (position A in the
figure above) engage the lower edge of the mounting plate.
2. Secure the cover plate to the mounting plate with two M4 screws. The screws are supplied
with the assembly kit.
5.5.3

Installing mounting plate on an S7-300 standard rail

Procedure
A
Figure 5-9
Follow the steps below to fit the mounting plate to an S7-300 standard rail:
1. Place the mounting plate with the two protruding catches on the top edge of the S7-300
standard rail (position A in the figure above).
2. At the bottom, the mounting plate has two lugs with holes. Screw the lugs to the S7-300
standard rail (position B in the figure above). The required screws are supplied with the
mounting plate.
SCALANCE W786-x
Operating Instructions, 12/2021, A5E03678337-14
B
Side view of a mounting plate on an S7-300 standard rail
Installation and removal
5.5 Mounting with mounting plate
41