Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for TCL MOVEAUDIO S108
Summary of Contents for TCL MOVEAUDIO S108
- Page 1 MOVEAUDIO S108 USER MANUAL V1.0 | TW08...
-
Page 2: Table Of Contents
Contents Read this first ............................... iii Chapter 1. Get started ..........................1 Overview..................................1 Charge the battery ..............................1 Replace ear tips ................................3 Chapter 2. Make connections ........................4 Connect with a Bluetooth device ..........................4 Disconnect from a Bluetooth device ........................5 Reconnect with your devices ............................6 Chapter 3. -
Page 3: Read This First
• TCL Communication Ltd. does not assume any liability that may occur due to the use or application of the product described herein. Every effort has been made in the preparation... -
Page 4: Chapter 1. Get Started
Chapter 1. Get started This manual describes everything you need to know about your TCL MOVEAUDIO S108. If you need more information, visit www.tcl.com. Overview The indicator flashes white color to indicate the charge or 1. Case LED indicator communication status of the earbuds or the charging case. - Page 5 NOTES • For best results, do not insert your earbuds in the charging case if they are wet or dirty. • The low battery prompt tone is heard via the earbuds when the battery level for the earbuds is less than 10%. Charging case To charge the charging case, connect the case to a computer or a compatible USB adapter with the supplied USB Type-C cable.
-
Page 6: Replace Ear Tips
NOTES • It takes approximately 1.5 hours to fully charge the case using the supplied USB Type-C cable. The charging time may vary depending on the battery usage conditions. • Use only the supplied or a certified USB charging cable for charging to prevent product damage. -
Page 7: Chapter 2. Make Connections
1. Take out your earbuds from the charging case, and keep them next to your device. The earbud LED indicators flash in blinking white. 2. Unlock your device, and turn on the Bluetooth function on your device. 3. Select TCL MOVEAUDIO S108 from the list of available devices to complete the connection. TCL MOVEAUDIO S108 NOTES • When you pair the earbuds with a device for the first time after purchase or after... -
Page 8: Disconnect From A Bluetooth Device
2. Triple-press either earbud, and hold the third press for about 4 seconds. 3. Unlock your device, and turn on the Bluetooth function. 4. Select TCL MOVEAUDIO S108 from the list of available devices to complete the connection. TCL MOVEAUDIO S108... -
Page 9: Reconnect With Your Devices
Reconnect with your devices After successful pairing, the earbuds will automatically connect to the last paired device if taken out of the charging case. NOTES • The earbuds and Bluetooth device must be turned on and within connection range. • If the earbuds cannot find and connect to the last paired device, they will enter pairing mode shortly. -
Page 10: Chapter 3. Use Your Earbuds
Chapter 3. Use your earbuds Tap or press the touch control area on the earbuds to control your music, phone calls, and other useful functions without getting out your phone. Music feature You can perform the playback controls by tapping your earbuds. Double tap either earbud Play or pause Triple tap left earbud... -
Page 11: Voice Assist Feature
1. Disconnect earbuds from your Bluetooth device, then tap either earbud 4 times. 2. The earbud LED indicators flash in blinking white when the earbuds enter reset process. TCL MOVEAUDIO S108 NOTE After reset process, the earbuds will enter pairing mode automatically. -
Page 12: Important Safety Information
Important safety information Read all safety information before using your product. Failure to follow these safety instructions could result in injury, or damage to your product or other property. Important handling information Handle your earbuds and the case with care. They contain sensitive electronic components, including batteries, and can be damaged if dropped, burned, punctured, crushed, disassembled, or if exposed to excessive heat or liquid. -
Page 13: Battery
If you use a third-party charger, the recommended output voltage/current of the adaptor is 5Vdc/1A.,and the adapter shall be CE approval type. Battery Do not attempt to replace the device batteries yourself. You may damage the batteries, which could cause overheating and injury. The batteries in your device should be serviced only by an authorized service provider. -
Page 14: Regulatory Compliance Information
Regulatory compliance information This section introduces regulatory information, certification, and compliance information specific to your product. Electromagnetic fields (EMF) This product complies with all applicable standards and regulations regarding exposure to electromagnetic fields. FCC compliance statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. -
Page 15: Declaration Of Conformity
/www.tcl.com/global/en/service-support- mobile/eu-doc.html Disposal and recycling information At TCL, we continually strive to improve our operations and products, and minimize our impact on the environment. Your product is designed and manufactured with high quality materials and components, which can be recycled and reused. -
Page 16: Troubleshooting
Check your country's local waste regulations for the proper How to dispose of my earbuds? disposal of electronic products. For more information, visit www.tcl.com. Connection problems Problem Solution • Make sure you have turned off the Bluetooth function of all previously paired devices. - Page 17 After putting my earbuds back To disconnect the earbuds from your device, close the lid in the charging case, I find they after putting your earbuds back in the charging case. are still connected to my device. Can I connect my earbuds to You can't connect your earbuds to multiple devices at the multiple devices at the same same time.
- Page 18 • Some smartphones receive calls with the phone instead of the earbuds by default. You need to operate your During a call using the earbuds, I smartphone to switch the call to your earbuds. can't hear the voice of the caller. • Increase the volume of your earbuds.
-
Page 19: Trademarks
Bluetooth SIG, Inc. and any use of such marks by TCL Communication Ltd. is under license. USB Type-C™ is a trademark of USB Implementers Forum. Google Assistant word mark and logo are trademarks or registered trademarks of Google Inc.
Need help?
Do you have a question about the MOVEAUDIO S108 and is the answer not in the manual?
Questions and answers