Lippert Components SOLERA POWER AWNING Head Replacement

Hide thumbs Also See for SOLERA POWER AWNING:

SOLERA

Purpose

This document describes the removal and replacement of the Solera® Power Awning drive head and motor.

• 1-3 people (depending on task)

• Cordless or electric drill or screw gun

• Appropriate drive bits

• Zip ties

Original Power Awning Head

266146

Prior to July 2017

Failure to secure the outer arms may result in personal injury, product or property damage. Pressure

from the gas strut can cause the outer arm to kick open, which could cause injury, product or property

Rev: 09.05.18

POWER AWNING HEAD REPLACEMENT

Moving parts can pinch, crush, or cut. Keep clear at all times.

AWNINGS

Current Power Awning Head

672049

After July 2017

damage.

Page 1

CCD-0002116

Table of Contents

Do you have a question about the SOLERA POWER AWNING and is the answer not in the manual?

Page 1 SOLERA POWER AWNING HEAD REPLACEMENT ® AWNINGS Purpose This document describes the removal and replacement of the Solera® Power Awning drive head and motor. Resources Required • 1-3 people (depending on task) • Cordless or electric drill or screw gun •...
Page 2 SOLERA POWER AWNING HEAD REPLACEMENT ® AWNINGS Instructions Removal Extend the awning about 12" away from the unit. Secure both support arm assemblies by running a zip tie around the outer arm and around the pin on the top of the mount arm where the mount arm and inner arm connect (Fig. 1). Fig.
Page 3 SOLERA POWER AWNING HEAD REPLACEMENT ® AWNINGS Fig. 2 If necessary, install the new power wire in the awning. To do this: A. Manually extend the awning by: Connecting the wires from the drive head assembly to a power source and run the awning halfway out.