Alula RE101 Quick Manual

Resolution Compatibles
Door Window Sensor
with industry-leading wireless range and battery life. It is
typically used to sense opening and closing of doors and
windows, but can secure just about anything using its two
external contact zones. It will alarm when the magnet is
pulled away from the sensor or when an external contact
is opened.
Features
• Industry-leading wireless range and battery life
• One door window zone and two external contact zones
• Secure encrypted wireless transmissions
• 5 year warranty
Enroll
by placing the panel into wireless enrollment mode and
then sending an enrollment signal from the sensor.
Enrollment Signal for Reed Switch
• Remove the battery tab and trip tamper to enroll
reed switch and External 1
Enrollment Signal for External Contact
• External 2 is enrolled by holding down tamper
while installing battery
Install
by mounting the sensor and magnet on a door or
window using the mounting screw locations. Make sure
to align the alignment marks on the sensor and magnet
when mounting. Additionally, the sensor can be used with
up to two external contacts.
External Contacts
• Use normally-closed contacts because the door
window sensor will transmit an alarm when it sees
an external contact open
• Do not use end-of-line resistors
• Wire contact wires to one or both outside
terminals, using the center terminal as common
• External 1 takes the place of the reed switch if
installed
• External 2 is a different zone with a different ID
• To enroll, hold down tamper while inserting
battery
Use the panel installation guide to verify proper system setup.
Door Window Sensor
RE101, RE201, RE201T, RE301, RE601
is a full-featured security transmitter
Mounting Screw Holes
I