Advertisement
CLASSIFICATION
SUBJECT
CUSTOMER'S CODE
PAN9320ETU
Scope of this document
This document gives the customer a very brief description of how to set up the
PAN9320ETU and evaluate its functions in six steps with a Microsoft Windows based
PC.
Actual Revision HW 2.0
Actual Revision SW 1.0
1.
The PAN9320 contains an integrated web-stack that provides a lot of features.
For detailed description and how these features can be used, please read the Software
Command Specification available at our website:
2.
For powering up the PAN9320ETU, you only have to connect the USB0 Port to your
USB-Port at your development PC. The USB1 is connected to the Uart1 of the module
and features its Netcat TCP-Data-Tunnel capability.
Please make sure the jumpers at the Motherboard (MB) are set as shown in the
picture below:
The VCC-LED and the Ready-LED on the ETU should be continuously lit on. Further
the MSStatus-LED is blinking green. Now the module is ready to work with.
3.
At the first time connecting the PAN9320 to your PC you will be asked to install FTDI
drivers. A DualRS232 FTDI chip is used on the board to provide a connection to the
PAN9320 UART via virtual USB Com-Port.
The standard driver will create two virtual COM-ports. One is for JTAG-via-USB and
the other one is connected to UART0 (Command Interface Uart) on PAN9320. In your
Quick Start Guide
PAN9320ETU
PANASONIC'S CODE
PAN9320ETU
No.
DS-SG-QSG-9320ETU
PAGE
DATE
DS-CS-CommSpec-9320
REV.
0.1
2 of 5
28.04.2015
Advertisement
