Tyre Pressure Monitoring System (Tpms) - Mitsubishi MOTORS ECLIPSE CROSS 2018 Owner's Manual

CAUTION
• When the vehicle is leaning much to one
side due to heavy luggage on it or improp-
erly adjusted tyre pressures.
• When oncoming vehicles' headlamps
shine the sensor.
• When the vehicle is equipped with non-
standard tyres (including excessively
worn tyres and temporary spare tyre),
uses snow traction device (tyre chains), or
has non-specified components such as a
modified suspension.
• When the windscreen is covered with wa-
ter droplets, snow, dust, etc.
l Follow the instructions given below to keep
your LDW in good operating conditions.
• Always keep the windscreen clean.
• Avoid applying a strong shock or pressure
to the sensor. Do not attempt to detach or
disassemble it.
• Do not put anything like a sticker on the
area in front of the sensor of the wind-
screen.
• Use only MITSUBISHI MOTORS GEN-
UINE parts when replacing the wind-
screen wipers.
Tyre pressure monitoring
system (TPMS)*
The tyre pressure monitoring system (TPMS)
uses tyre inflation pressure sensors (A) on the
wheels to monitor the tyre inflation pressures.
The system only indicates when a tyre is sig-
nificantly under-inflated.
The base tyre pressure can be set at desired
value by the driver with the reset function ex-
ecution. (The low pressure warning threshold
is set based on the reset.)
The tyre inflation pressure sensor IDs for two
sets of tyres can be registered by a
MITSUBISHI MOTORS Authorized Service
Point, and the valid ID set can be switched by
the multi-information display switch (It's
beneficial in case of seasonal tyre change be-
tween summer tyre and winter tyre.)
OGKE19E1

Tyre pressure monitoring system (TPMS)*

WARNING
l The spare tyre with a speed limit label
does not have a tyre inflation pressure
sensor.
When the spare tyre with a speed limit la-
bel is used, the TPMS will not work prop-
erly. See an MITSUBISHI MOTORS Au-
thorized Service Point as soon as possible
to replace or repair the original tyre.
NOTE
l
The TPMS is not a substitute for regularly
checking tyre inflation pressures.
Be sure to check the tyre inflation pressures
as described in "Tyres" on page 10-10.
l
The tyre inflation pressure sensor (B) is in-
stalled in the illustrated location.
• On vehicles equipped with the Type 1
sensor which has the metallic air valve
(C), replace grommet and washer (D)
with the new ones when the tyre is re-
placed.
• On vehicles equipped with the Type 2
sensor which has the rubber air valve (E),
replace rubber air valve (E) with new one
when the tyre is replaced.
For details, please
MITSUBISHI MOTORS Authorized Serv-
ice Point.
Starting and driving
6
contact your
6-105