Installation - Taramps DS 800X4 Instruction Manual

Installation

CAUTION: All connections to power supply, input and output connectors must be carried
out only with amplifier off.
Recommended wire gauge & fuse
Positive / negative power supply cable __________________________________________ 7 AWG
Output cables wire gauge___________________________________________________15 AWG
Remote cable _____________________________________________________________18 AWG
Protection fuse or circuit breaker__________________________________________ _______60A
Caution: Using wire gauges below the recommendation will result in power loss and overheating
of wiring.
Check polarity and never reverse power supply cables due to the risk of damage to the amplifier.
Calculated considering a maximum length of 4m. Distance greater than this, you will need to
increase the cable gauges.
It is compulsory to install protection fuses or circuit breakers as close as possible from batteries.
Subwoofer
Woofer
Connection example in the output: Stereo + Bridged
12V
Note: Required battery bank capacity:
At least 60Ah
Note: In case of horns and tweeters you must install a passive filter in the positive terminal of the
same ones (Consult transducer's manufacturer manual).
4 ohms
DS 800X4 2
2 ohms
DS 800X4 1
Remote Cable 18 AWG
4 ohms
4 ohms DS 800X4 2
2 ohms 2 ohms
DS 800X4 1
4 ohms 4 ohms
*Illustrative images
2 ohms 2 ohms
RCA Cable
Taramps
RCA Cable
Taramps
If the head unit doesn't have
the 4 RCA outputs, use ''Y'' type
cable adapters for properly 4
inputs connection of amplifier.
DS 800X4 2
DS 800X4 1
Head Unit
11