Advertisement
Quick Links
HD Turret and Bullet
Camera
User Manual
UD05432B
User Manual
Thank you for purchasing our product. If there are any
questions, or requests, do not hesitate to contact the
dealer.
This manual applies to the models below:
Type
Type I Camera
Type II Camera
Type III Camera
Type IV Camera
Type V Camera
This manual may contain several technical incorrect
places or printing errors, and the content is subject to
change without notice. The updates will be added to
the new version of this manual. We will readily improve
or update the products or procedures described in the
manual.
Model
THC-T120
THC-T110
THC-T120-P
THC-T110-P
THC-T220-P
THC-T210-P
THC-B220
THC-B210
THC-B120/THC-B120-P
THC-B110/THC-B110-P
0200001070807
Advertisement
Related Manuals for HiLook ТНС-Т120
Summary of Contents for HiLook ТНС-Т120
- Page 1 HD Turret and Bullet Camera User Manual UD05432B User Manual Thank you for purchasing our product. If there are any questions, or requests, do not hesitate to contact the dealer. This manual applies to the models below: Type Model THC-T120 Type I Camera THC-T110 THC-T120-P...
-
Page 2: Regulatory Information
Regulatory Information FCC Information Please take attention that changes or modification not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. FCC compliance: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. - Page 3 Safety Instruction These instructions are intended to ensure that user can use the product correctly to avoid danger or property loss. The precaution measure is divided into “Warnings” and “Cautions”. Warnings: Serious injury or death may occur if any of the warnings are neglected.
-
Page 4: Product Features
1 Introduction Product Features The camera is applicable for both indoor and outdoor conditions, and the application scenarios include road, warehouse, underground parking lot, bar, etc.. The main features are as follows: High performance CMOS sensor Low illumination, 0.01 Lux@(F1.2, AGC ON), 0 Lux ... - Page 5 1.2.3 Overview of Type III Camera Enclosure Main Body Switch Button Power Cord DC12V Mounting 12 VDC Base Video Cable Figure 1-3 Overview of Type III Camera Note: Press and hold the switch button for 5 seconds to switch the video output. Four kinds of video outputs are available: TVI, AHD, CVI, and CVBS.
-
Page 6: Installation
2 Installation Before you start: Make sure that the device in the package is in good condition and all the assembly parts are included. Make sure that all the related equipment is power-off during the installation. Check the specification of the products for the ... - Page 7 Note: Drill the cable hole, when adopting the ceiling outlet to route the cable 5. Attach the mounting base to the ceiling, and secure them with supplied screws Figure 2-3 Attach the Mounting Base to the Ceiling Note: The supplied screw package contains self-tapping ...
- Page 8 2.2 Installation of Type III Camera Before you start: Both wall mounting and ceiling mounting are suitable for the camera. We take ceiling mounting as an example in this section. You can take the steps of ceiling mounting as a reference, when adopting wall mounting. Steps: 1.
- Page 9 Figure 2-9 Secure the Camera with Mounting Base 8. Connect the corresponding cables, such as power cord, and video cable. 9. Power on the camera to check whether the image on the monitor is gotten from the optimum angle. If not, adjust the camera according to the figure below to get an optimum angle.
- Page 10 3. Attach the bracket to the ceiling and secure the camera with supplied screws. Figure 2-12 Fix the Camera to the Ceiling Note: The supplied screw package contains self-tapping screws, and expansion bolts. For cement ceiling, expansion bolts are required to ...
-
Page 11: Menu Description
3 Menu Description Purpose: Call the menu by clicking button on the PTZ Control interface, or call preset No.95. Steps: 1. Connect the camera with the TVI DVR, and the monitor, shown as the figure 3-1. Figure 3-1 Connection 2. Power on the analog camera, TVI DVR, and the monitor to view the image on the monitor. - Page 12 Figure 3-3 AE BRIGHTNESS Brightness refers to the brightness of the image. You can set the brightness value from 1 to 10 to darken or brighten the image. The higher the value, the brighter the image is. EXPOSURE MODE You can set the EXPOSURE MODE as GLOBAL, or BLC. GLOBAL ...
- Page 13 lights (e.g.: incandescent light). The image switches from color to B/W or from B/W to color automatically according to the light condition. You can turn on/off the INFRARED and set the value of SMART IR under SMART 1 or SMART 2 mode. Figure 3-4 DAY NIGHT INFRARED ...
- Page 14 3.3.4 RESET Move the cursor to RESET and click Iris+ to reset all the settings to the default. 3.3.5 SAVE-EXIT Move the cursor to SAVE-EXIT and click Iris+ to save the setting and exit the menu. UD05432B-A...
Need help?
Do you have a question about the ТНС-Т120 and is the answer not in the manual?
Questions and answers