Installation - Taramps DS 250x2 Instruction Manual

Installation

CAUTION: All connections to power supply, input and output connectors must be
carried out only with amplifier off.
Recommended wire gauge & fuse
Positive / negative power supply cable _________________________________11 AWG
Output cables with gauge__________________________________________ 15 AWG
Remote cable ____________________________________________________
Protection fuse or circuit breaker_______________________________________
Caution: Using wire gauges below the recommendation will result in power loss and
overheating of wiring.
Check polarity and never reverse power supply cables due to the risk of damage to the
amplifier.
Calculated considering a maximum length of 4m. Distance greater than this, you will
need to increase the cable gauges.
It is compulsory to install a protection fuses or circuit breakers as close as possible from
batteries.
4mm² (11 AWG)
Note: In case of horns and tweeters you must install a passive filter in the positive
terminal of the same ones (Consult transducer's manufacturer manual).
4 ohms 4 ohms
4 ohms
Connection example in the output: Stereo
12V
GND
Remote Cable 18 AWG
4 ohms
*Illustrative images
RCA Cable
Taramps
Head Unit
ENGLISH
18 AWG
_
20A
__
11