Cubii JR1+ Owner's Manual page 16

IV. Using Your Cubii JR1+
Console Profile Reset
User 1 and User 2 profiles can be reset from the console. Simply
select the relevant user profile then hold the User button for 3
seconds then release the button to complete the profile reset.
Resetting the user profile from the built-in console erases any data
stored for that profile and also delinks the profile from the app. The
profile can be easily re-established in the app if needed.
Manual Data Reset
Manually reset data for any profile on the console (User 1, User
2 or Guest) by selecting the relevant profile (see User Button
section above) and then holding the Mode button for 3 seconds
then release the button to complete the profile reset. This action
resets any data displayed on the screen for the selected profile.
Distance Metric Toggle
To switch from miles to kilometers (or kilometers to miles), use the
MODE button to select the Distance metric. Then, hold the MODE
button for 6 seconds. If you are using the Cubii app, this update will
also be reflected there.
Manually Set a "Smart Reset"
If you do not pair your elliptical to the Cubii app, but still want
your console to reset each evening at midnight, follow the
instructions below to set the clock to the current time:
1. Simultaneously press the USER and MODE buttons 3 times in a
row to reset the clock. It should flash "00:00".
2. Press the USER button to cycle through hours until you get to
the right hour. Note that the clock uses military time.
3. Press the MODE button to cycle through minutes until you get
to the right minute.
12