Table of Contents
Advertisement
Available languages
Available languages
Quick Installation Guide
13
Connect wires from Step 8.
Depress the tabs to put the
wires into the inner holes of their
corresponding terminals on the
UWP (one wire per terminal) until it is
firmly in place.
Gently tug on the wires to verify
they are secure.
Tip: If you need to release the wires
again, push down the terminal tabs
on the sides of the UWP.
14
Confirm wiring matches snapshot.
Please confirm wiring matches
terminals from the photo you took in
Step 5.
15
Mount the UWP and close the
door.
Mount the UWP using the provided
screws. Install all three screws for
a secure fit on your wall. Close the
door after you're finished.
16
Install batteries.
Insert two AA alkaline batteries in the back of the thermostat as shown.
17
Attach your thermostat.
Align the thermostat onto the UWP
and firmly snap it into place.
This wiring is just an example,
yours may vary.
6
Use 3x supplied
screws #8 1-1/2"
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the RTH6360D1002 and is the answer not in the manual?
Questions and answers
Como entro al cistema de configuración?
To access the configuration system for the Honeywell Home RTH6360D1002 thermostat:
1. Press and hold the Menu and + buttons together for about 5 seconds.
2. The Advanced Setup Menu (ISU) will appear.
3. Press Select to enter the System Configuration Menu.
4. Use the + or - buttons to change values or select available options.
5. Press Select to save changes and move to the next configuration setting.
6. Continue until all settings are configured.
7. When finished, the screen will display Done. Press Select to save and exit.
To exit early, press the Home button.
This answer is automatically generated