Table of Contents
Advertisement
Settings
Settings
3
Rotate the image (
1
) if necessary, then
confirm the selection (
2
).
A confirmation message appears. Touch [Enter]
to store the new image. (The existing image is
replaced with the new one.)
<Viewing Angle>
Select the viewing angle in relation to the monitor to
make the image on the screen easier to see.
• 0 (Initial)/–1/–2/–3
40
ENGLISH
User interface settings
Display the <User Interface> screen.
On the Home screen, touch as follows:
Then, on the <SETUP> screen, touch [User Interface].
<Steering Remote Controller>
Assign functions to the keys on the remote controller
of the steering wheel.
• This function is available only when your car is
equipped with the electrical steering remote
controller.
• You can only register/change the functions while
you are parked.
• If your steering remote controller is not compatible,
learning may not be completed and an error
message may appear.
1
Press and hold a steering remote
controller button for about 2 seconds to
register/change when the unit is ready for
learning.
2
Select a function to assign to the selected
button.
3
Repeat steps 1 and 2 to register other
functions to other buttons.
4
Touch [Learning completed] to finish
procedure.
To change the previously assigned function:
1 Touch the key to change on the <Steering
Remote Controller Setting> screen.
2 Select a new function to assign from the pop-up
list.
3 Touch [Change completed] to finish the
procedure.
Advertisement
Table of Contents
