Assembly And Adjustments; Operation - DeWalt DCF6201 Instruction Manual

ASSEMBLY AND ADJUSTMENTS


WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury.
Fitting the Collated Screwdriver Bit
(Fig. A, B)
NOTICE: For proper operation only use D
screwdriver bit (catalog #: DWA6PHC2).
1. Remove the nose cone from the screwgun.
2. To remove the bit and bit holder:
a. Grab the bit holder.
b. Push it into the gear case depressing the sleeve.
c. Rotate the bit holder until the clutch engages.
d. While holding the sleeve depressed, pull the bit holder
out.
NoTE: Refer to and follow all instructions on
changing bits and holders in your screwgun manual.
3. Push and rotate the provided collated screwdriving bit
8 into the spindle until ball lock snaps in groove of the
bit shank.
Installing and Removing the Magazine
from the Screwgun (Fig. B)
With the the nose cone removed and provided driver bit
8 installed, push the magazine over the bit onto the screw
driver until the magazine clicks into place and ensure that it
does not disengage.
Fig. B
NoTE: make sure the screw driver control lever is set to
forward rotation before use.
To remove the magazine, press and hold the release
buttons 7 on both sides of the accessory and pull accessory
off the screwgun.

OPERATION


WARNING: Always observe the safety instructions
and applicable regulations.

WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury.
Proper Hand Position (Fig. C)

Proper hand position requires one hand on the rear grip.
Take care to not block the air vents on the screwgun.
WALT collated
e

Fig. D
8
7
Setting Magazine Screw Length (Fig. E)
This magazine is designed for 1"– 2" (20– 50 mm) screw
lengths. Failure to set the correct screw length can cause
screws to not be driven accurately which can result in the
failure to advance to the next screw or screws not being
driven properly. The shoe has marked specific slots for each
of the most common screws, however this attachment can
still drive any size screw between 1"– 2" (20– 50 mm). To
accommodate for less common screws adjust to the next
longest slot.

1. Slide screw length adjustment tab
WARNING: To reduce the risk of serious personal
injury, ALWAYS use proper hand positions as shown
in Figure C.
Fig. C
CAUTION: NEVER grip the collated attachment,
use it as a handle or touch the screw strips while in
operation as shown in Figure D.
CAUTION: Do not adjust while a screw strip is in the
magazine.
ENglIsh
2 to the left.
15