Table of Contents
Advertisement
Manual setup
In the following cases, configure each setting as necessary.
– When connection test failed with auto setting.
– When instructed by your Internet service provider to make specific settings in accordance with your Network
environment.
1. Press [HOME] and use [
2. Use [
] to select "Network", then press [OK].
3. Use [
] to select "Network installation", then press [OK].
4. Use [
] to select "Start", then press [OK].
5. Use [
] to select "Manual setup", then press [OK].
6. Use [
] to select the desired setting (IP Address / Subnet Mask / Default Gateway / Primary DNS /
Secondary DNS), then press [OK].
• The range of input numbers is between 0 and 255.
• Use [
] to move between input fields. Use [
press [RETURN].
7. When all items are entered, use [
8. Use [
] to select "Yes" or "No" for proxy server, then press [OK].
• If you use a proxy server, select "Yes" then press [OK] to go to the next step.
• If you do not use a proxy server, select "No" then press
9. "Proxy Address" setting screen will appear. Enter a proxy address using the cursor buttons, the color buttons,
and [OK].
10. Press [RED] to go to the "Proxy Port" setting screen.
[
• If you Use
setting screen.
11. Use [
12. Connection test confirmation screen will appear. Select "Yes", then press [OK] to start the connection test.
The test result will appear right after the connection test finishes.
13. "Network connection succeeds." will be displayed. Select "Finish", then press [OK] to complete the settings.
Note
D
• Enter an IP address after checking the specifications of your router.
• If an IP address is unknown, check the IP address of other devices (e.g. PC connected with a LAN cable). Then, in the
fourth cell to the right, assign a different number from those other devices.
• Enter the DNS addresses provided by your Internet Service Provider.
• If the DNS address is unknown, check the DNS address of other devices (e.g. PC connected via LAN cable) and assign
the same DNS address.
• The range of input numbers for the port number is between 0 and 65535. (This number must be no greater than
65535.)
• For proxy port, certain ports might be closed, blocked or unusable depending on your network environment.
• When the settings are changed, the network connection may be disabled depending on the device.
EN
] to select "Setup" in the home menu, then press [OK].
]
to select "Done" then press [OK] instead of [RED], you can go to the "Proxy Port"
] to change the proxy port number, then press [OK].
] changes the number by 1. If you want to exit this setting,
] to select "Continue", then press [OK].
[OK]
to go to step 12.
44
Advertisement
Table of Contents
