Notes
• When using a two-speaker installation, the Green, Green/Black, Violet, Violet/Black wires,
which are used for a four-speaker installation, are not used. The ends of these wires must
be covered with electrical tape to prevent them from shorting to the unit or the vehicle chassis.
Fuse 15A
Burnt
LINE OUT/CD CHANGER CONNECTIONS
The unit has a built-in CD changer controller and line output terminals. You can use a compatible Sanyo
•
CD changer and a separate amplifier to upgrade your system.
CD Changer
CD Changer DIN Socket
Connect the 8-pin DIN cable, which is supplied with the Sanyo CD changer, to the DIN socket on the back
•
of the unit.
RCA Line-out Jacks (For Speakers)
Connect a patch cable (not supplied) from the White (left channel) and Red (right channel) RCA line output
•
jacks to the line input terminals of the external amplifier.
NG
OK
CD Changer
DIN Socket
• When using a two-speaker installation, set the
FADER control to the center position.
• When fuse replacement is necessary remove
the blown fuse by using pliers.
Then install the new 15 amp. fuse.
RCA Line-out Jacks
FRONT REAR
Rear Speaker
-26-
OUTPUT
White
L (eft)
R (ight)
Red
External
Amplifier
Front Speaker