Specifications; Table 1-1 Minicapt Remote Microbial Air Sampler Specifications - Particle Measuring Systems MiniCapt 100R Operation Manual

Specifications

Specifications

Table 1-1 MiniCapt Remote Microbial Air Sampler Specifications

Sampling flow rate
Communication
Dimensions (h, w, d)
Weight
Operating environment
Maximum altitude
Calibration interval
Electrical rating
Voltage fluctuation
Materials
Number of inlets
Compressed Gases Sampling Kit
Isolator Monitoring Kit
Remote ISP Sampling Kit
MiniCapt Remote Microbial Air Sampler Operations Manual
25R
25 Liters/minute
Modbus TCP
Enclosure: 7.2 x 5.9 x 6.3 in (18 x 15 x 15 cm)
7.4 lb (3.4 kg) without BioCapt Microbial Impactor
Temperature: 32 - 104 °F (0 - 40 °C); Humidity: 10 – 90% RH
6,562 ft (2000 m)
Recommended every 12 months
Utility Requirements
100 – 240 V, 50 – 60 Hz, 1.0 A
AC input voltage fluctuation shall not exceed + 10%
Installation Requirements
Indoor use only
Pollution degree 2
Over-voltage Category II
Ordinary Protection (Not protected against harmful ingress of
moisture.)
Class I Equipment (Electrical earth ground from the mains power
source to the product input is required for safety.)
BioCapt Impactor Head
AISI 316L Stainless Steel
20 (precision-cut slits)
Accessories
50R
50 Liters/minute
Chapter 1 Introduction
100R
100 Liters/minute
Page 1-5