Self Clean Interrupted - Miele 11 918 970 Operating Instructions Manual

36 inch all gas range (gas oven and gas cooktop)
Table of Contents

Advertisement

Cleaning and care of the oven
The audible signal will stop and the
symbols on the display will go out.
Danger of injury caused by hot
surfaces.
At the end of the Self Clean program,
the oven will still be very hot. You
could burn yourself on the heater
elements and the oven
compartment.
Allow the heating elements and the
oven compartment temperature to
drop to a safe level before removing
any residues.
 Clean the oven compartment to
remove any Self Clean residues (e.g.,
ash) that can build up depending on
the degree of soiling in the oven
compartment.
Most residues can be removed with
warm water, liquid dish soap, and a
clean sponge or a clean, damp
microfiber cloth.
Depending on how dirty the oven was
prior to cleaning, there may be a
visible layer of soiling across the inner
glass pane on the door. You can
remove this using the scouring side of
a dish sponge, a glass scraper, or with
a stainless steel spiral pad and liquid
dish soap.
Please note:
- There is a fiberglass seal around the
oven compartment which seals the
inside of the glass oven door and can
be damaged by rubbing and
scouring. Do not clean the door seal
– it is essential for sealing the door
properly.
78
- Spilled fruit juices may cause lasting
discoloration of enameled surfaces.
This discoloration is permanent but
will not affect the properties of the
enamel. Do not attempt to remove
these stains.

Self Clean interrupted

If the Self Clean program is canceled,
the oven door will remain locked until
the temperature inside the oven drops
to below 535°F (280°C).  remains lit
up until the temperature of the oven
compartment has fallen below this
temperature. When  flashes, the
door is unlocked.
The following events will cause the Self
Clean program to stop:
- The mode selector is turned to Off.
Once the door has been unlocked, 
will go out and the time of day will
appear. Start the Self Clean program
again if necessary.
- The mode selector is turned to a
different operating mode.
 and  appear. Once the door has
been unlocked,  will go out and 
will flash. Start the Self Clean
program again if necessary.
- A power failure occurs.
 and  appear. Once the door has
been unlocked,  will go out and 
will flash.
When power is restored,  remains
lit up until the temperature of the
oven compartment has fallen below
535°F (280°C).  will then appear.
The door is unlocked and the time of
day will appear.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Hr 1136-3 agHr 1134-3 agHr 1135-3 ag

Table of Contents