Time Adjustment; Adjusting The Current Time Setting - Casio 5553 Operation Manual

Note
Auto Light is disabled when any one of
●
the conditions below exists.
Alarm, timer alert, or other beeper
ー
sounding
Configuring the Auto Light Setting
●
1.
Enter the Timekeeping Mode.
Navigating Between Modes
l
2.
Hold down (B) for at least three seconds
to toggle Auto Light between enabled and
disabled.
[LT] is displayed while Auto Light is
●
enabled.
If you do not disable it manually, Auto
●
Light remains enabled for
approximately six hours. After that, it
becomes disabled automatically.
On
Watch Operation Guide 5553
Specifying the Illumination Duration
●
You can select either 1.5 seconds or three
seconds as the illumination duration.
1.
Enter the Timekeeping Mode.
Navigating Between Modes
l
2.
Hold down (A) for at least two seconds.
Release the button when [SET] starts to
flash.
3.
Press (C) 10 times to display [LIGHT].
4.
Press (D) to select an illumination
duration.
[1]: 1.5-second illumination
[3]: 3-second illumination
5.
Press (A) to complete the setting
operation.

Time Adjustment

Use the procedures in this section to adjust the
date and time settings.
Adjusting the Current Time
Setting
Use the procedures below to adjust the
current date and time settings, and to select a
Home City.
Setting a Home City
●
Use the procedure in this section to select a
city to use as your Home City. If you are in an
area that observes summer time, you can also
configure a summer time setting.
1.
Enter the Timekeeping Mode.
Navigating Between Modes
l
2.
Hold down (A) for at least two seconds.
Release the button when [SET] starts to
flash.
3.
Use (B) and (D) to change the Home City
setting.
Holding down (B) or (D) scrolls through
●
settings at high speed.
For details refer to the information
●
below.
City Table
l
8