Sealey LP69C Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to Hot surfaces
instructions
1. SAFETY
This product is not suitable for primary heating purposes.
1.1. ELECTRICAL SAFETY
WARNING! It is the user's responsibility to check the following:
‰
1.1.1. Check all electrical equipment and appliances to ensure that they are safe before using. Inspect power supply leads, plugs and
all electrical connections for wear and damage. Sealey recommend that an RCD (Residual Current Device) is used with all electrical
products. You may obtain an RCD by contacting your local Sealey stockist.
1.1.2. If the product is used in the course of business duties, it must be maintained in a safe condition and routinely PAT (Portable
Appliance Test) tested.
Electrical safety information, it is important that the following information is read and understood.
1.1.3. Ensure that the insulation on all cables and on the appliance is safe before connecting it to the power supply.
1.1.4. Regularly inspect power supply cables and plugs for wear or damage and check all connections to ensure that they are secure.
Important: Ensure that the voltage rating on the appliance suits the power supply to be used and that the plug is fitted with the
correct fuse - see fuse rating in these instructions.
DO NOT pull or carry the appliance by the power cable.
8
DO NOT pull the plug from the socket by the cable.
8
DO NOT use worn or damaged cables, plugs or connectors. Ensure that any faulty item is repaired or
8
is replaced immediately by a qualified electrician.
This product is fitted with a BS1363/A 3 pin plug.
If the cable or plug is damaged during use, switch off the electricity supply and remove from use.
Ensure that repairs are carried out by a qualified electrician.
Replace a damaged plug with a BS1363/A 3 pin plug. If in doubt contact a qualified electrician.
a) Connect the GREEN/YELLOW earth wire to the earth terminal 'E'.
b) Connect the BROWN live wire to the live terminal 'L'.
c) Connect the BLUE neutral wire to the neutral terminal 'N'.
Ensure that the cable outer sheath extends inside the cable restraint and that the restraint is tight.
Sealey recommend that repairs are carried out by a qualified electrician.
1.1.5. If an extension reel is used it should be fully unwound before connection. A reel with an RCD fitted is preferred since any appliance
plugged into it will be protected. The cable core section is important and should be at least 1.5mm
that the capacity of the reel is suitable for this product and for others which may be used in the other output sockets, we recommend the
use of 2.5mm section cable.
2
1.2. GENERAL SAFETY
WARNING! Disconnect heater from mains electrical supply and gas cylinder before servicing or performing maintenance. Replace or
‰
repair damaged parts. Use genuine parts only. Unauthorised parts may be dangerous and will invalidate the warranty.
WARNING: DO NOT use for heating of habitable areas of domestic premises or for use in public buildings, refer to national regulations.
‰
WARNING: DO NOT use in basements or areas below ground.
‰
Use only in a well ventilated area and away from combustible materials.
9
Store gas cylinders in accordance with regulations applicable to such appliances.
9
Ensure that nothing stands or passes in front of the heater. Mandatory minimum distance from the heater is 2 metres at the front.
9
Only use the propane gas pressure regulator and hose assembly supplied with the heater, without alteration.
9
Only use outdoors or in well ventilated surroundings in a well ventilated area away from combustible materials.
9
Ensure continuous ventilation is provided to the heater operating area. A ventilation opening must run to the outside of the premises where the
9
heater is to be operated. The opening must be 100cm
heater operating area.
WARNING: If the heater is used for prolonged periods at maximum power, ice may form on the propane cylinder. This is because of
‰
excessive evaporation. In such a case DO NOT use the heater to de-ice the cylinder.
WARNING: If the smell of gas is present, isolate the gas cylinder immediately and investigate the reason before re-connecting it.
‰
DO NOT use the heater if damaged. Take immediate action to repair or replace damaged parts. Use an authorised service agent only.
8
DO NOT use the heater for residential use or in recreational vehicles.
8
DO NOT allow untrained persons to ignite the heater.
8
© Jack Sealey Limited
30,000-68,000BTU/HR (9-20KW) 2-IN-1
CORDLESS/CORDED SPACE WARMER®
PROPANE HEATER
LP69C
MODEL NO:
Electric shock
Not for
Hazard
residential use
for every kW and must also be set at an equal distance from the upper and lower parts of the
2
Original Language Version
Do Not cover Keep Dry
, but to be absolutely sure
2
LP69C
Replacement fuse
rating: 3A
Issue 2 (3) 06/07/21