Do you have a question about the Homeline KA20IC and is the answer not in the manual?
Questions and answers
Frank Schlund
January 30, 2025
The KA201C bed does not pai with remote followed instruction for pairing replaced the battery in the remote have not use unit in a long time purchased in 2018
1 comments:
Mr. Anderson
February 10, 2025
To pair the Linak Homeline KA20IC bed with the remote after replacing the battery, follow these steps:
1. Ensure the KA20IC system is correctly installed and connected to power. 2. Activate Bluetooth® pairing mode on the KA20IC. 3. Follow the instructions in the user manual to pair the remote. 4. If the system has reached the maximum of four paired controls, the first paired control will be forgotten when a new one is added. 5. You can also use the LINAK app to pair a smartphone as a handset if needed.
This answer is automatically generated
Ken Dieter
February 27, 2025
How do I adjust the bed without remote control that is lost
3. Pairing another device later ......................16 KA20IC system ............................ 16 Functional description ........................17 Labels ..............................18 Disposal of LINAK products ......................19 Main groups of disposal ........................20 Disposal of batteries ......................... 20 Drawing appendix ..........................21 LINAK application policy ........................22 Addresses ............................
This User Manual does not address the end-user. It is intended as a source of information for the manufacturer of the equipment or system only, and it will tell you how to install, use and maintain your LINAK electronics. It is the responsibility of the manufacturer of the end-use product to provide a User Manual where relevant safety information from this manual is passed on to the end-user.
Important information Important information on LINAK products can be found under the following ® headings: Warning! Failure to comply with these instructions may result in accidents involving serious personal injury. Failing to follow these instructions can result in the product being damaged or being destroyed.
Page 6
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation •...
Page 7
- Reorient or relocate the receiving antenna. - Increase the separation between the equipment and the receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/ TV technician for help. This device complies with Industry Canada licence-exempt RSS standard(s).
Electromagnetic fields (EMF): This LINAK appliance complies will all standards regarding electromagnetic fields (EMF). If handled properly and according to instructions in this user manual, the appliance is safe to use based on scientific evidence available today. Page 8 of 36...
Only for EU markets This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved.
Informations importantes Les informations importantes sur les produits LINAK peuvent être trouvées dans ® les rubriques suivantes: Attention! Le non respect de ces instructions peut entraîner des accidents impliquant des blessures graves. Ne pas suivre ces instructions peut entraîner l´endommagement ou destruction du produit.
• Les produits ne doivent-être utilisés que dans un environement qui correspond à leur IP. Divers: Le système d´actionneur présente un niveau sonore inférieur à 55dB (A) dans des applications typiques. Les mises à jours des manuels et autres informations peuvent-être trouvées sur www.linak.com/homeline Page 11 of 36...
Seulement pour les marchés au sein de l´UE: Cet appareil peut-être utilisé par des enfants âgés de 8 ans et plus, ainsi que les personnes dont les capacités physiques, sensorielles ou mentales sont réduites ou ayant un manque d´expérience et de connaissance si elles ont bénéficié...
Repairs In order to avoid the risk of malfunction, all KA20IC repairs must only be carried out by authorised LINAK workshops or repairers, as special tools must be used and special gaskets must be fitted. KA20IC under warranty must also be returned to authorised LINAK workshops.
There is 36 months’ warranty on the KA20IC product against manufacturing faults calculated from the production date of the individual products (see label). LINAK A/S’ warranty is only valid in so far as the equipment has been used and maintained correctly and has not been tampered with.
KA20IC - Start-up (How to pair Bluetooth connection) It is possible to pair multiple devices to the KA20IC via Bluetooth . See following instructions: ® 1. Pairing your control Connect the KA20IC to the mains using the SMPS. Now the KA20IC will be in pairing mode in 3 minutes and the Under Bed Light will blink to indicate this.
3. Pairing another device later If you wish to connect another control or a smartphone/tablet to the KA20IC later, just disconnect, wait 2 minutes and connect the KA20IC to the mains to get it in pairing mode again. See instructions 1 or 2 above to find out how to pair the device, you want.
Functional description Hand Control HB10BL: Up – down back motor Up – down leg motor Common operation up/down (option) Light Button Hand Control HC05BL: Up – down back motor Up – down leg motor Common operation up/down (option) Light Button Hand Control HC10BL: Up –...
Disposal of LINAK products As LINAK customers often ask us how our products can be disposed of or scrapped we have prepared this guidance that enables a classification to different waste fractions for recycling or combustion. Guidance We recommend to disassemble our product into as many fractions as possible at the disposal and try to make it recycable. As examples of main groups within waste fractions we can mention: Metal, plastic, cable shoe, combustible waste and collection for recovery.
Details regarding safe disposal of used and leaking batteries: Batteries should be disposed in accordance with appropriate federal, state and local regulations. LINAK recommends that used or leaking batteries are disposed through the local recycling system. Please do not throw used or leaking batteries in normal household waste or in nature.
LINAK customer using any LINAK product. LINAK shall be responsible solely that the LINAK products comply with the specifications set out by LINAK and it shall be the responsibility of the LINAK customer to ensure that the specific LINAK product can be used for the application in question.
While LINAK uses its best efforts to fulfil orders, LINAK cannot, for the same reasons as mentioned above, guarantee the availability of any particular product. Therefore, LINAK reserves the right to discontinue the sale of any product displayed on its website or listed in its catalogues or other written material drawn up by LINAK.
Need help?
Do you have a question about the Homeline KA20IC and is the answer not in the manual?
Questions and answers
The KA201C bed does not pai with remote followed instruction for pairing replaced the battery in the remote have not use unit in a long time purchased in 2018
To pair the Linak Homeline KA20IC bed with the remote after replacing the battery, follow these steps:
1. Ensure the KA20IC system is correctly installed and connected to power.
2. Activate Bluetooth® pairing mode on the KA20IC.
3. Follow the instructions in the user manual to pair the remote.
4. If the system has reached the maximum of four paired controls, the first paired control will be forgotten when a new one is added.
5. You can also use the LINAK app to pair a smartphone as a handset if needed.
This answer is automatically generated
How do I adjust the bed without remote control that is lost