Resetting The Switch (Gs1900-24 Revision B1 / Gs1900-24Ep / Gs1900-24Hpv2 / Gs1900-48 Revision B1 / Gs1900-48Hpv2 Only); Restore Button; Reboot The Switch - ZyXEL Communications GS1900 Series User Manual

Note: If you want to access the Switch Web Configurator again, you may need to change
the IP address of your computer to be in the same subnet as that of the default Switch
IP address (192.168.1.1).
3.5 Resetting the Switch (GS1900-24 Revision B1 / GS1900-
24EP / GS1900-24HPv2 / GS1900-48 Revision B1 / GS1900-
48HPv2 only)
Use the RESTORE button to reset the Switch back to factory defaults. Use the RESET button to reboot the
Switch.

3.5.1 Restore Button

Press the RESTORE button for more than 6 seconds until the SYS LED begins to blink. The Switch will
automatically reboot and restore the factory default file. See
information about the LED behavior.

3.5.2 Reboot the Switch

Press the RESET button to reboot the Switch without turning the power off. See
more information about the LED behavior.
Chapter 3 Hardware Overview
GS1900 Series User's Guide
42
Section 3.3 on page 40 for more
Section 3.3 on page 40 for