Hkcu-4001 St 2110 Interface Kit (Option); Hkcu-4002 12G-Sdi Extension Kit (Option) - Sony HKCU-IP43F Operation Manual

HKCU-4001 ST 2110 Interface Kit
(Option)
Note
For safety, only a qualified technician with service training
should perform tasks inside the unit.
Connection with devices that are SMPTE ST 2110 compliant
is supported by installing an HKCU-4001 to the HDCU4300.
HDCU4300 software version 2.00 or later is required. An
OTM-10GSR1 or other SFP+ module or SFP28 module is
required to use IP output.
a LAN-1, LAN-2 connectors (SFP+/SFP28)
IP video signals and audio input/output, intercom, and network
synchronization are supported. This enables three IP outputs
and two IP inputs for HD signals on the HDCU4300.
For RCP/MSU device connection and IP tally input, use the
LAN-COM connector.
The input/output signal format is set using the <OUTPUT
FORMAT2> page and <RETURN> page in the setup menu.
HKCU-4002 12G-SDI Extension Kit
(Option)
Note
For safety, only a qualified technician with service training
should perform tasks inside the unit.
The HDCU4300 supports 4K 2-system 12G-SDI output or
6G-SDI output by installing an HKCU-4002 in the HDCU4300.
HDCU4300 software version 1.50 or later is required.
For details about installation, contact a Sony service or sales
representative.
a 12G/6G-SDI output connectors
These connectors are 12G-SDI output connectors or 6G-SDI
output connectors. The output format is the same as the
format set for SLOT1 of the HDCU4300.
For details, see page 37.
1
1
11