Connecting Via Wps - Miele DAD 4840 Operating And Installation Instructions

Before using for the first time

Connecting via WPS

Your WiFi router must support WPS
(WiFi Protected Setup).
 With the deflector plate retracted,
touch the On/Off switch .
All symbols light up with reduced
brightness.
 Press and hold the run-on option
control  until the grease filter 
and charcoal filter  symbols light
up.
 Touch 2.
The deflector plate extends.
2 will light up constantly, 3 will flash.
The WiFi connection must be started on
the cooker hood at the same time as on
the WPS router.
 Press B on the cooker hood after a
few seconds.
After a short while, 2 will light up
constantly, and 3 and B will flash.
The cooker hood is ready for
connection for the next two minutes.
20
 Start the WPS connection on your
WiFi router.
When successfully connected, 2 and
3 will light up constantly.
 Quit connection mode on the cooker
hood by touching the run-on option
control .
The cooker hood can now be operated
via the app.
If the connection fails, you have
probably not activated WPS on your
router quickly enough. Repeat the steps
above.
Tip: If your WiFi router does not support
WPS, please connect via the Miele app.