Belt And Stabilizer Guide Track Brackets - Lippert Components Bed Lift Assembly And Operation Manual

21. Fasten the motor mounting bracket (Fig. 11A) to the motor mount support (Fig. 11B) with two 4.2 mm
x 13 mm screws (Fig. 11C). On the opposite end of the motor mounting bracket install two 4.2 mm x 13 mm
screws through the bracket and into the end rail (Fig. 11D).
D

Belt and Stabilizer Guide Track Brackets

Make sure to keep a minimum 5 mm (
lift. Install the belt brackets (Fig. 12B) as close as possible to the side of the bed (Fig. 12C) to avoid tip-over
when under load.
Wall Side
A
Wall Side
Rev: 11.19.20
13/64
in) gap (Fig. 12A) between the two belts on each side of the bed
D
5mm
Minimum
Distance
C
D
Fig. 11
A
Fig. 12
Page 10
C
B
A
C
B
B
CCD-0002764