General Information - Sulzer AHLSTAR 2.15 Series Installation,Operation And Maintenance Instruction

1 General
The pump and its accessories may only be used for the purpose for which they have been supplied.
The intended use is given in the order specification and in the following instructions concerning the main pumping
parameters and mechanical durability. If the intended use changes, the user must make sure that the pump can be
used in the new application and, if necessary, obtain the manufacturer's permission for the change.
The maximum allowable working pressure of the pump is indicated in the product specification (under
Table 1, Intended use in the process
Application data:
Pumped liquid and its properties (chemicals, solids,
consistency, temperature etc.)
Main pumping parameters (capacity, head, speed etc.)
Other necessary process data
Table 2, Delivery and design
Delivery and design data:
Product scopes (modules)
Product size
Other design alternatives (impeller type and size, materials,
lubrication, flange drillings, shaft sealing type etc.)
Maximum allowable working pressure
Dimensions (pump, accessories, flanges etc.)
Weights and mass moments of inertia (bare pump, pump +
baseplate etc.)
Connections (lubrication, shaft seal, drainage etc.)
Part details (maximum impeller diameter, bearing types,
fastener sizes etc.)
This instruction set covers the process pump with the supplementary accessories included in the delivery. All
supplied instructions are found in the parts list under the heading "Customer instructions".
Before commissioning, the operating staffs have to be instructed in the guidelines for correct and safe operation of
the product as stated in these instructions. This product must be serviced by qualified personnel who are familiar
with the design and operation of this product and the system with the essential safety aspects involved. The scope of
responsibilities and supervision of the personnel must be exactly defined by the plant operator.
ORIGINAL INSTRUCTION
USER'S MANUAL – AHLSTAR
Intended use
item pump). Please note this also when using a frequency converter.
SPP id: 141101 / Replaces 140901 / en / N31567 / 4 / Page 2 (7)
W A R N I N G
C A U T I O N
Sources:
Product specification (under "Process data")
Product specification (under "Process data") and nameplate of
the pump
Product specification (under "Process data")
Sources:
Product specification
Product specification and nameplate of the pump
Product specification
Product specification
Dimensional drawings
Dimensional drawings
Location shown in the parts list and in the sectional drawings
and dimensional drawings. Moreover, connections having
importance in view of safety have been marked on the
product.
Parts list (under heading "Parts")
Series 2.15 Page
INSTRUCTIONS ISO
November 2014 G
COPYRIGHT © SULZER PUMPS FINLAND OY