Thank you for selecting American Standard - the benchmark of fine quality for over 100 years. To ensure this product is installed properly, please read
these instructions carefully before you begin. (Certain installations may require professional help.) Also be sure your installation conforms to local codes.
CAUTION: PRODUCT IS FRAGILE. TO AVOID BREAKAGE AND POSSIBLE INJURY HANDLE WITH CARE!
!
NOTE: Pictures may not exactly define contour of china and components.
TANK 4188A and 4188B
BOWL 3517A, 3517C, 3517F ELONGATED
BOWL 3517B, 3517D ROUND FRONT
Wax Ring
SOLD SEPARATELY
Product names listed herein are trademarks of AS America, Inc.
Summary of Contents for American Standard Cadet PRO Series
Page 1
Models 215AA, 215BA, 215AB, 215BB, 215FA, 215FC, 215CA, 215DA, 215CB, 215DB Series Thank you for selecting American Standard - the benchmark of fine quality for over 100 years. To ensure this product is installed properly, please read these instructions carefully before you begin. (Certain installations may require professional help.) Also be sure your installation conforms to local codes.
BEFORE YOU START: If Removing An Existing Toilet Flush to remove water from tank; Turn Off Water Supply Clean Flange sponge remaining water from bowl before removing toilet. Caution: If leaving floor flange open for more than 1-2 hours, cover flange to prevent escaping sewer gases.
Page 3
Apply weight evenly. Hand tighten Do not move after only. Do not overtighten. placement. Water tight seal may break. NOTE: 1/4" EZ-BOLT AND CAP SHOWN. IF 5/16" BOLT USE STANDARD DISK AND CAP INCLUDED. Tighten handles alternately until the tank contacts the front and back of the bowl achieving china-to-china...
WARNING: Do not use in-tank cleaners. These products can seriously corrode fittings in the tank. This damage can cause leakage and property damage. American Standard shall not be responsible or liable for any damage caused by the use of in-tank cleaners.
Page 5
INSTRUCTIONS D’INSTALLATION ET D’ENTRETIEN Cadet Toilette 2 pièces PRO ® Devant allongé et rond Modèles 215AA, 215BA, 215AB, 215BB, 215FA, 215FC, 215CA, 215DA, 215CB, 215DB Series Merci d’avoir choisi American-Standard... la référence en matière de qualité depuis plus de 100 ans. Afin de vous assurer que le produit est installé correctement, veuillez lire attentivement les instructions avant de commencer.
AVANT DE COMMENCER : Si Vous Enlevez Une Toilette Déjà Installée Tirez la chasse Nettoyez la bride Fermez l’alimentation en eau pour vider l’eau du réservoir; épongez l’eau restante de la cuvette avant de retirer la toilette. Avertissement: Si la bride au sol demeure ouverte plus de 1 à...
Page 7
Appliquez du poids Serrez à la main uniformément. seulement. Ne Ne pas bouger la serrez pas toilette après l'avoir excessivement. placée. Le seau étanche risque REMARQUE : de briser. ILLUSTRATION : BOULON DE 1/4 PO À USAGE FACILE ET CAPUCHON. SI UN BOULON DE 5/16 PO EST REQUIS, UTILISER LE DISQUE...
MISE EN GARDE : N’utilisez pas de nettoyants pour cuvette. Ces produits peuvent sérieusement corroder les raccords de tuyauterie du réservoir. Ces dommages peuvent entraîner des fuites et des dommages matériaux. American Standard n’assume aucune responsabilité pour tout dommage causé...
Modelos de las series 215AA, 215BA, 215AB, 215BB, 215FA, 215FC, 215CA, 215DA, 215CB, 215DB Gracias por seleccionar American Standard, el punto de referencia de la calidad por más de 100 años. Para asegurar que no haya problemas durante la instalación, lea atentamente estas instrucciones antes de comenzar (algunas instalaciones pueden requerir ayuda profesional). Asegúrese también de que su instalación cumple con los códigos locales.
ANTES DE COMENZAR: Si Está Quitando Un Inodoro Existente Cierre el suministro de agua Limpie la brida Descargue el inodoro para quitar el agua del tanque; saque con una esponja el agua restante de la taza antes de quitar el inodoro. Precaución: Si deja la brida del piso abierta por más de 1-2 horas, cubra la brida para...
Page 11
Apriete a mano Aplique peso solamente. uniformemente. No No apriete lo mueva después excesivamente. de la colocación ya que el sello impermeable podría romperse. Nota: Se muestra el perno EZ de 1/4" y la tapa. Si se usa el perno de 5/16"...
ADVERTENCIA: No utilice limpiadores para el interior del tanque. Estos productos pueden corroer gravemente los accesorios en el tanque. Este daño puede causar fugas y daños a su propiedad. American Standard no será responsable ni sujeto a acción legal por cualquier daño causado por el uso de limpiadores dentro del tanque.
Need help?
Do you have a question about the Cadet PRO Series and is the answer not in the manual?
Questions and answers