GOSUN FLOW User Manual

Portable, battery-powered solar water filter & pump

Hide thumbs

page of 32

/ 32
Bookmarks

Quick Links

Download this manual

Need help?

Do you have a question about the FLOW and is the answer not in the manual?

Questions and answers

Summary of Contents for GOSUN FLOW

Page 2 C - Pump and filter water 12-13 D - Pump water without filter 14-15 E - Using faucet / sink / shower 16-17 F - Make hot water with GoSun Fusion 18-19 G - Make hot water with submersible heater 20-21 Maintenance 22-23...
Page 3 Ensure that all the water you drink is microbiologically filtered by your GoSun filter. There is no guarentee that you won’t become sick while traveling. However, you can make sure that your drinking water is microbiologically safe with your GoSun filter.
Page 4 35°F (2°C) - 131°F (55°C). Please clean or replace the polyproplylene filter disc if it becomes dirty, to prevent bacteria growth. If the flow rate significantly drops, replace filter cartridge immediately. Flush filter cartridge with clean (or filtered) water after using. Drain well, then air-dry.
Page 5 (this page is intentionally blank...
Page 6 Par s Storage Case Powerbank Long Hose Water Filter Water Pouch Short Hose Water Pump Extra Filters Intake Hose...
Page 7 Available Accesso ies Portable Sink Basin Faucet / Shower GoSun Thermo Submersibale heater Powerbank...
Page 8 Storage Ca e How to position parts in Storage Case 1. The Pump, Filter and Powerbank get stored in the Top half of the Storage Case (the half with the solar panel) 2. To secure a part, open the velcro strap. Place the part down onto the rubber pad and firmly close the velcro strap.
Page 9 Filter Parts Third Stage: Nano Alumina Fiber Removes 99.99% of viruses and 99.9999% of bacteria from water. Second Stage: High-Efficiency Carbon Filter Absorbs odors, hazardous chemicals, and heavy metals First Stage: Polypropylene Filter Disc Removes suspended impurities such as dirt, sand and rust...
Page 10 There are a few situations that would indicate it is ti e to replace your filter cartridge: 1. The flow rate through the filter is reduced to roughly one half the original flow rate (please make sure the intake hose pre-filter, and sediment filter disk are not dirty/clogged before replacing the main filter cartridge).
Page 11 (this page is intentionally blank...
Page 12 Mode Filter only (sucking) 1. Open Storage Case 2. Remove the Filter from the case. 3. Attach the intake hose with the pre-filter screen to the input of the filter. Place the intake hose screen into the water. 4. Suck to filter water 5.
Page 13 Mode Filter only (bottle or bag) 1. Open Storage Case 2. Remove the Filter from the case. 3. Attach the included foldable water bag, or other standard 20 Oz or 2 liter plastic drink bottle that has been filled with unfiltered fresh water to the filter input.
Page 14 Mod C Pump and filter water 1. Open Storage Case 2. Locate the three hoses - Short, Long and Intake 3. Insert end of intake hose through the Left port and connect to the Intake side of Pump 4. Attach one end of the Short hose to the Outtake side of Pump, and the other end to the Intake side of the Filter 5.
Page 15 Locate freshwater source (not salt water), and place the Intake screen into it For optimal performance, please ensure that the screen is suspended fully in the water Y ou may need to adjust the float to achieve this Place the loose end of the Long hose into your desired collection vessel Plug Pump USB cable into the Solar Panel or Powerbank and enjoy fresh, filtered water!
Page 16 Mod D Pump water without the filter 1. Open Storage Case 2. Locate the two hoses - Long and Intake 3. Insert end of intake hose through the Left port and connect to the Intake side of Pump 4. Insert end of the Long hose through the Right port and connect to the Outtake side of the Pump 5.
Page 17 If using for drinking water, please ensure that the water source is potable Place the loose end of the Long hose into your desired collection vessel Plug Pump USB cable into the Solar Panel or Powerbank and enjoy!
Page 18 1. Follow Steps 1-6 in Mode C (pump and filter) or D (pump only). For the shower, we recommend not using prefiltered water and not having the filter in-line. This will provide the best flow rates. 2. Connect the loose end of the Long hose to the intake stem on the faucet housing 3.
Page 19 Locate the three-part cable split and connect the components to it as shown below Pop up the Sink basin and attach the faucet clamp to the sink, table, or other desired location Press the button next to the faucet spout to turn the water on / off Y ou may need to wait a few seconds on first use for the water to come out Enjoy! (Optional): use heated water: please refer to Mode F &...
Page 20 1. Only use filtered or potable water (free of particulates which could clog the pump) 2. Locate GoSun Fusion and Vertical Tilt Leg Kit 3. Insert the Legs into the Bracket 4. Tilt the open end of the Fusion up, and insert the Bracket into the Fusion end as shown 5.
Page 21 Fusion to the Sun, and close end with the Cap, letting the water heat up inside To pump the water with Flow, follow steps 1-5 in Mode D Take the Intake Screen off the of Intake hose and insert that end of...
Page 22 3. Place the Heater end of the Submersible Heater into your water source. Please ensure that the water vessel can safely hold heated water. (Optional - for more efficient heating, you can use the GoSun Fusion as a vessel. In that case please follow steps 1-5 in Mode F)
Page 23 Plug the Submersible Heater into the Powerbank and turn the Powerbank on To pump the water with Flow, follow steps 1-5 in Mode D To use the heated water with the Sink or Shower, follow steps 2-7 in Mode E Caution Do not let water exceed 120˚F (40˚C) because that can...
Page 24 Main enance Filter cleaning and storage Shor erm s orage Perform these steps when the filter will not be used for 2-3 days or after filtering 100-200 gallons of water 1. Filter a small amount (1-2 cups) of water into a clean container for flushing your filter assembly.
Page 25 Check the polypropylene filter If the polypropylene filter is persistently dirty, replace it with a fresh filter Reassemble the filter cartridge, then reassemble the filter housing with filter cartridge installed Long term storage Allow all three filter elements to air dry completely (this may take 2 days or more in some environments) before reassembly Do not dry the filter in direct sunlight or in a heated enclosure, the UV rays from direct sunlight...
Page 26 Main enance How to charge and use the powerbank Charge he Powerbank in several ways: 1. Charge wi h any USB source: to charge the powerbank with another USB source (a larger powerbank, wall charger, or other solar phone charger) simply connect the input of the power bank to the new charging source to start charging.
Page 27 Power with the Powerbank, while charging the solar panel: If solar charging the powerbank, the Flow can still be used, but the flow will work at a reduced rate if in the shade If the solar panel is not receiving enough sunlight for the Flow to function as desired,...
Page 28 Troubleshootin Problem Probable Cause r a t fl o 3 stage filter may be clogged r a t r a t fl o fl o 3 stage filter may be clogged 3 stage filter may be clogged n n i t i l l n n i n n i...
Page 29 Solution Please reference “Filter Replacement” on page 9 Please reference “Filter Replacement” on page 9 Please reference “Filter Replacement” on page 9 Clean the intake filter by flushing with Clean the intake filter by flushing with Clean the intake filter by flushing with clean water clean water clean water...
Page 30 “Authorized Dealer” means any distri utor, reseller or retailer that was duly authorized y GoSun at the time of the sale to sell authentic GoSun products in the jurisdiction where it sold the Product, and that sold the Product in new, unused condition in its original packaging.
Page 31 Need help? +1 888.868.61 4 support@gosun.co gosun.co/help-center...