If The Camera Is At 169.254.1.1; Status Lights; Installing The Wall Mount - VADDIO IntelliSHOT Installation Manual

If the Camera Is At 169.254.1.1

This is the camera's default IP address. This means one of these things:
The camera's PoE+ power injector is not connected to the network,
n
OR
The network does not automatically assign IP addresses.
n
If the camera does not receive an IP address when connected to the network, you will need to configure
the camera for the network after you have done the initial device set-up.
To communicate directly with the camera for initial device set-up and network configuration, you will need
to connect a cable from your computer's network port to the DATA IN port on the PoE+ power injector.

Status Lights

The lights in the camera's head indicate its current state.
Purple – Initializing
n
White – Active
n
Red – Audio is muted
n
Blinking red – Video is muted
n
Yellow – Firmware update is in progress
n
Blinking cyan – Remote pairing mode
n
Blinking blue – Pairing error
n
Caution
Do not remove power or reset the camera while the status lights are yellow, showing a firmware update in
progress. Interrupting a firmware update can make the camera unusable.
Note
By default, the camera's status lights are active during normal operation; however, they can be
configured to remain off when the camera is powered up. The camera may be sending video even if the
lights are off.

Installing the Wall Mount

The camera is shipped with a wall mount. Other mounting options are available as well. Contact us if you
don't have the camera mount you need.
You can install the camera wall mount to a display mount or directly to the drywall. If you mount it to
drywall, use wall anchors.
Installation Guide for the IntelliSHOT Auto-Tracking Camera
6