Cleaning; Specifi Cations; Troubleshooting - Panasonic Straight & Curl EH-HV10 Operating Instructions Manual

Cleaning

Clean the straightener or Cap (H) after they have cooled and
with the plug removed from the power outlet.
• Do not touch the body until it has cooled down.
• To clean the straightener or Cap (H), use a cloth that has
been soaked in soap and water and well wrung out.
• Do not use alcohol, thinner, benzine or remover.
Doing so may crack or discolor the surface of the
straightener.

Troubleshooting

Problem
During use, the unit gives off a burning
smell.
The Iron Plate does not get hot.
The main body is partially deformed.
If the problems still cannot be solved, contact the store where you purchased the unit or a service center authorized by
Panasonic for repair.
EH-HV10_ME_EN.indb 13 EH-HV10_ME_EN.indb 13
Specifi cations
Model No.: EH-HV10
Power source
Power consumption
Iron temperature
*Only available in Kuwait and Qatar.
This product is intended for household use only.
Possible cause
Dust etc. are adhered to the Iron Plate.
The cord is disconnected.
100 - 240 V
240 V
50 - 60 Hz
22 W
Approx. 210 ˚C
Action
Clean the Iron Plate to
remove any adherents.
Stop using immediately.
13/01/2015 10:50:48 AM 13/01/2015 10:50:48 AM
50 Hz*
13