DeWalt DXF2475 Manual page 8

English
4.Turning Fan On: Place fan on stable level surface.
Plug fan into properly grounded outlet. To start the
fan,turn the switch from the OFF position to the
desired fan speed.
5.Turning Fan Off: To turn the fan off, turn the
switch from the current fan speed setting to the off
position. Remove plug from outlet.
6.Adjusting Fan Tilt: Loosen the adjustment knob
until the drum rotates freely on the frame. Adjust the
fan to desired tilt angle and re-tighten the knob. Do
not overtighten adjustment knob.
WARNING:
Before assembling the fan, make sure all parts are
present. Compare parts with contents list. If any part
is missing or damaged, do not attempt to assemble,
install, or operate the product. Contact customer
service for replacement parts. Unplug fan before
assembling any parts to it.
7. Tools Required (Not Included):
Wrench(open end 17mm).
#2 Phillips Screwdriver or Suitable Drill Equipped with
#2 Phillips Bit.
8.Fan Cradle Assembly:
required to use this fan.
Frame Axle shaft
1 2
Wheel Washer
4 5
Short screw Nut
7 8
• Insert through the hole on the
7
secure with .
8
• Slide and in , then insert
6 5 4
put them into the hole on
CARE and MAINTENANCE
Cleaning:
Before cleaning the fan be sure to
CAUTION:
disconnect power cord from the plug. Clean the grill
surface with a clean damp cloth. Do not use harsh
chemical or abrasive cleaners.
WARNING: DO NOT IMMERSE THE FAN OR ANY
WIRES IN WATER. Replace front grill before fan use and
allow fan to dry completely before use. Periodic grill
cleaning with a vacuum will prevent dust build up. The
motor is sealed and does not require any interior
maintenance, cleaning or lubrication.
Simple assembly is
Sleeving
3
Long screw
6
Foot pad
9
and ,
1
9
into ,
3 6
, then tighten .
2 6
Maintenance: The Internal motor bearings are
permanently lubricated at the factory and do not require
any additional lubrication.
Repair:
DO NOT OPERATE THE FAN WITHOUT
WARNING:
THE GRILL IN PLACE. DO NOT USE THE FAN IF IT
HAS MALFUNCTIONED OR BECOME DAMAGED IN
ANY WAY.
Storage: Keep original carton for storage of the fan.
Coil and tie the power cord to avoid damage during
storage.
Protecting the environment
Separate collection. Products and batteries
marked with this symbol must not be
disposed of with normal household waste.
Products and batteries contain materials that can be
recovered or recycled reducing the demand for raw
materials. Please recycle electrical products and
batteries according to local provisions. Further
information is available at www.2helpU.com
Optional Accessories
Since accessories, other than those
WARNING:
offered by D WALT, have not been tested with this
E
product, use of such accessories with this appliance
could be hazardous.
To reduce the risk of injury, only D
accessories should be used with this product.
TROUBLESHOOTING
WARNING:
TO REDUCE THE RISK OF INJURY FROM
MOVING PARTS AND/OR ELECTRICAL SHOCK,
TURN POWER SWITCH OFF AND DISCONNECT
GROUNDED PLUG FROM ELECTRICAL OUTLET
BEFORE PERFORMING TROUBLESHOOTING
CHECKS.
Minor problems often can be xed without calling
customer service.
If the supply cord is damaged, it must
WARNING:
be replaced by the manufacturer, its service agent or
similarly quali ed persons in order to avoid a hazard
TOOL GUARANTEE
3
8
WALT recommended
E
YEAR
LIMITED
GUARANTEE