Room Inputs - Philips dynalite DDRC-GRMS-E Commissioning Manual

Signify Classified - Internal
DDRC-GRMS-E
.......................................
Commissioning Guide
.......................................
Page 8
.......................................
1.7

Room inputs

The table below shows the factory default DDRC-GRMS-E input configuration.
Input Switch Name
Input 1 Bedside Right
Input 2 Bedside Left
Input 3 Bedside (Both)
Input 4 Room Lighting (1)
Input 5 Room Lighting (2)
Input 6 Corridor Lighting
Input 7 Room and Corridor
Input 8 Bathroom Lighting (1)
Input 9 Bathroom Lighting (2)
Input 10 Sheers Open/Close
Input 11 Blinds Open/Close
Input 12 Do Not Disturb (DND)
Input 13 Make Up Room (MUR)
Input 14 Pick Up Laundry (PUL)
Input 15 Doorbell
Input 16 Emergency
Input 17 Master Lighting
Input 18 Keycard Switch
March 5, 2019
Function
Toggles the bedside lights on/off
Toggles the room's lights on/off
The default configuration allows for two sets of lights that can be
toggled separately or together, such as downlights and lamps, or
main and mood lighting.
Toggles the corridor lights on/off
Toggles the corridor and room lighting on/off
Toggles the bathroom lights on/off.
Short press: Starts/Stops motorized sheer curtains.
Long press: Changes direction of travel before fully open/closed.
Short press: Starts/Stops motorized blinds.
Long press: Changes direction of travel before fully open/closed.
Toggles the room status indicators outside the room.
MUR is disabled when DND is active.
Triggers a third-party doorbell.
Sets all lighting channels to ON.
If any lights are ON, turns all lights OFF.
If all lights are OFF, toggles Room Lighting (1) and Bathroom
Lighting (1) to ON.
When keycard is inserted, turns on Air Conditioner, GPO, Corridor
Lighting and Room Lighting (All) channels.
When keycard is removed, waits 5 seconds then turns off all
lights, Air Conditioner and GPO, closes the blinds and locks all
button panels.
www.lighting.philips.com/dynalite