Contents 1. Brief overview ..............3 1.1 Toilet unit ............... 3 1.2 Remote control ............. 3 2. Description of Symbols ............3 3. For your safety ..............4 3.1 Normal Use ..............4 3.2 Safety instructions ............4 4. Basics of operation ............8 4.1 Remote control ..............
Page 6
7. Cleaning and Care ............18 7.1 Seat and lid ..............18 7.2 Spray wand and nozzle ..........18 Manual cleaning of the spray wand and nozzle .... 18 Self-cleaning of the spray wand and nozzle ....19 7.3 Remote control ............19 8.
1. Brief overview 1.1 Toilet unit 1.2 Remote control Power Infrared transmitter Status LED Rearwash Rearwash Ladywash Ambient light sensor Comfortwash Ladywash Spray wand position Infrared receiver Water temperature Night light Seat temperature Soft closing mechanism Stop Seat heating Battery Compartment The overviews referred to are collected together on the fold out page.
These operating instructions correspond to the device’s state of technology at the time of printing. Duravit reserves the right to make changes in terms of further development. 3.1 Normal Use...
Page 9
• Do NOT detach seat and lid for any purpose. • Do NOT damage the surface of the seat. • If the surface of the seat is damaged, contact help@duravit.com. • DO NOT open and close seat and lid with excessive force.
Page 10
• Repairs must be carried out by qualified electricians or techni- cians. • Improperly performed repairs can lead to accidents, damage and malfunctions. • Do NOT use attachments not recommended by Duravit. Use of batteries Risk of fatal injury if swallowed/Chemical WARNING burn hazard This product contains coin / button cell batteries.
Page 11
with hot surfaces or direct sunlight. Otherwise there is a risk of leakage. > The cells shall be disposed of properly, including keeping them away from children. Even used cells may cause injury. NOTICE Product and/or property damage > Batteries may not be recharged, reactivated by other means, dis- mantled or exposed to fire.
4. Basics of operation 4.1 Remote control SensoWash is operated via the remote control. Settings are ® altered via the remote control as well. Press the respective button on the remote control to switch on a function. The button lights up white briefl y. To switch off a shower function, press “Stop”...
4.2 Status LEDs Red illuminated: SensoWash is in the ”Standby mode“, all func- ® tions cannot be used. Orange illumina- SensoWash is in the ”Energy saving mode“, all ® ted: functions can be used. Green illumina- SensoWash is in the ”On mode“, all functions ®...
6. Operating 6.1 Switching the SensoWash on / off ® > Press “Power” on the seat unit to switch on SensoWash ® A green Status LED indicates “On mode”. > Press “Power” on the seat unit again to switch off SensoWash ®...
Activating / deactivating “Ladywash” Additional nozzle outlet for female intimate care. > Press Plus Ladywash is > Press Stop to or Minus to active, the end Ladywash activate La- spray wand or after 2 min. dywash. extracts slowly auto stop. Alternatively press “Ladywash”...
Adjusting the water spray intensity The water spray intensity can be set individually in 3 steps: Low > Medium > High Requirement: Rearwash or Ladywash function is activated and the icon illuminated. > Press Plus to > Press Minus increase the to decrease Rearwash the Rearwash...
> Press Right > Press Left arrow to arrow to retract the extract the spray wand. spray wand. Adjusting the water temperature The water temperature can be individually adjusted in 4 levels: > > Medium > High > Press Water Temperature to cycle through.
> Press Seat Temperature to cycle through. How to save energy see chapter 6.4 “Settings”. 6.4 Settings Adjusting the night light Illuminated inner bowl for night mode orientation, also visible with closed lid. In the Auto mode the night light will be switched on and off accord- ing to the surrounding brightness.
Energy saving mode Timed energy saving mode is to save energy at a desired point of time, e.g. at night. When the timed energy saving mode gets activated, the seat heat- ing is deactivated for the next 8 hours and then gets automatically reactivated for 16 hours.
Activating / deactivating the confirmation tone To indicate any command. Press the following button combination to cycle through the confirmation tone settings. Therefore, the stop button has to be pressed constantly. > Press Lady- > Press and wash Plus. hold Stop. Short confirmation tone: Longer confirmation tone: Off Lock / unlock the remote control...
Page 21
> Press and > Press Spray > Press Spray > Press Water hold Stop. wand position wand position Temperature. Left arrow. Right arrow. > Press Seat Temperature. Spray wand position and Temperature icons flash three times: Locked Spray wand position and Temperature icons flash one time: Unlocked...
7. Cleaning and Care 7.1 Seat and lid Yellow discolouration or paint delamination due NOTICE to incorrect cleaner! > Do not use abrasive cleaning agents or cleaning agents contain- ing chlorine or acid. > Only use cleaning agents and equipment which is intended for this area of application.
Self-cleaning of the spray wand and nozzle Spray wand and nozzle are cleaned automatically. > Press and > Press > Press stop to hold Stop. Comfortwash end cleaning Plus. or after 90 sec. auto stop. Spray wand and nozzle are cleaned automatically before and after each use.
3 hours and then reconnect it again. If your unit does still not work properly after following the instructions mentioned below, contact Duravit help@duravit.com. Have the article and serial number ready. These can be found on the nameplate on the back of the operating instructions.
Page 25
® unit flashes red > Switch on twice each 3 SensoWash again. ® seconds. If flashing does not stop: contact help@duravit.com. The “Status Malfunction. > Contact LED” on the help@duravit.com. unit flashes red three times each 3 seconds. The “Status Malfunction.
Page 26
Problem Potential cause Solution General function SensoWash SensoWash > Switch on the main ® ® not working. not switched on power supply. (“Status LED” not illuminated). SensoWash is in > Switch to “On mode”. 6.1 ® Standby mode (“Sta- tus LED” is red illuminated).
Page 27
Problem Potential cause Solution The remote No batteries > Insert batteries. control does not are inserted. work. The batteries > Change the are flat. batteries. The battery connec- > Insert the batteries tions are reversed. the correct way. The remote control >...
Page 28
Problem Potential cause Solution The water tem- The water tempera- > Adjust the “Water perature is not ture has been set to temperature” warm enough. ”Off“ or ”Low“. ”Medium“ or ”High“. The water tem- The ”Water tempe- > Adjust the ”Water perature is too rature“...
Page 29
Night light function The night light The night light has This is normal. does not come been set to Off > Set the night light mode. to Auto or On mode. The night light is This is normal. in Auto mode and the ambient light is bright.
(0.7 - 7.5 bar) Water consumption in spray mode 0.35 - 0.60 l/min Protection degree IP X4 Protection against water spray from all sides Warranty Our warranty terms can be found in our General Terms and Conditions (GTC) at www.pro.duravit.com/gtc.
Need help?
Do you have a question about the SensoWash Slim 611000 00 2 10 0300 and is the answer not in the manual?
Questions and answers