Advertisement
6.
TROUBLESHOOTING
PROBLEM
Jack will not lift the load
Jack does not lift high enough or
feels "spongy"
Jack lifts poorly
Jack lifts but will not hold load
Jack will not lower completely
Jack does not lower at all
recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to a recycling
centre and disposed of in a manner which is compatible with the environment.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: no liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: for a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
© Jack sealey Limited
POSSIBLE CAUSE
1) overloaded
2) oil level low
3) release valve not closed
correctly
4) Air in system
5) Piston rod not functioning
6) Packing worn or defective
1) oil level too high or too low
2) Worn seals
3) Air in system
4) release valve not closed
1) Pump packing or valves
malfunctioning
2) oil is dirty
3) Air in the system
1) release valve partially open
2) Dirt on valve seats
3) Air in system
4) faulty seals
5) Packing worn or defective
1) unit requires lubrication
2) Piston rod bent or damaged
3) Jack frame/link system
distorted due to overloading/
poor positioning
4) Air in system
5) release valve partially
closed
6) Jack spring damaged
1) release valve closed
Environmental Protection.
Sole UK Distributor, Sealey Group,
Kempson Way, suffolk Business Park,
Bury st. Edmunds, suffolk,
IP32 7Ar
Original Language Version
REMEDY
1) Be sure to use jack with adequate capacity.
2) top up oil level.
3) check and close release valve.
4) open release valve and pump the handle a few times. close
valve and re-try.
5) clean and replace oil.
6) replace packing.
1) fill or remove excess oil.
2) return jack to local service agent.
3) open release valve and pump the handle a few times. close
valve and re-try.
4) check and close release valve.
1) replace packing and/or clean valves.
2) replace oil.
3) open release valve and pump the handle a few times. close
valve and re-try.
1) check and close release valve.
2) Lower jack, close release valve. Place foot on front wheel and
pull up lifting arm to full height by hand. open the release valve
lower arm.
3) open release valve and pump the handle a few times. close
valve and re-try.
4) replace or contact local service agent.
5) replace packing.
1) oil all external moving parts.
2) replace rod or contact local service agent.
3) replace damaged parts or contact local service agent.
4) open release valve and pump the handle a few times. close
valve and re-try.
5) check and fully open release valve.
6) replace spring or contact local service agent.
1) check and fully open release valve.
01284 757500
01284 703534
www.sealey.co.uk
Web
sales@sealey.co.uk
email
3000Es,5000Es,10000Es Issue: 1 - 04/04/14
Advertisement
