Canadian Decal Kit
For 2007 and After Toro Lawn Mower with Briggs and
Stratton Engine
Model No. 114-1584
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Step
1
Decals
Note: Visit www.Toro.com and download the French Operator's Manual that corresponds to the model
and serial number of the product on which this kit is installed.
Step
1
Installing the Decals
Parts needed for this step:
4
Decals
Procedure
Install the decals in the positions indicated in the
table below. Place each Canadian decal directly
over the corresponding US English decal.
Install each decal as follows:
1. Thoroughly clean the area where you will
install the decal.
2. Dampen the area with water or mildly soapy
water.
3. Peel the decal from the backing and install it in
place as shown in Figure 1.
© 2007—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Description
1. Decal 104-7908
2. Decal 112-8759
4. Squeegee across the surface of the decal,
Register at www.Toro.com.
Form No. 3357-705 Rev A
Installation Instructions
Qty.
4
Install the decals.
Figure 1
3. Decal 94-8072
4. Decal 112-8867
starting at the center of the decal and working
toward the edges, using overlapping strokes.
Original Instructions (EN)
Use
Printed in the USA.
All Rights Reserved