Generator Preparation; Step 1 Add Oil - Powersmart PS52 Instruction Manual

GENERATOR PREPARATION

The following section describes steps necessary to prepare the generator for use. If after reading this
section, you are unsure about how to perform any of the steps please call (800) 791-9458 Mon-Fri 9-5
EST for customer service. Failure to perform these steps properly can damage the generator or shorten its
lifespan.
Unpacking
Unpack the generator and all its parts. Do not discard the carton or any packaging until the generator is
completely assembled.
Step 1 - ADD OIL
The generator is shipped without oil. User must add the proper amount of oil before operating the
generator for the first time. The oil capacity of the engine crankcase is 20 fl. oz. For general use (above
40° F), we recommend 30W, 4-stroke engine oil.
ENGINE OIL RECOMMENDATIONS
Select good quality detergent oil bearing the American Petroleum Institute (API) service classifications
SJ, SL, or SM (synthetic oils may be used). Use the ASE viscosity grade of oil from the following chart
that matches the starting temperature anticipated before the next oil changes.
To add oil, follow these steps:
1. Make sure the generator is on a level surface. Tilting the
generator to assist in filling will cause oil to flow into engine
areas and will cause damage. Keep generator level!
2. Remove the left side maintenance cover.
3. Remove the dipstick from the engine.
4. Add oil slowly. Do not overfill.
5. To check the oil level, wipe the dipstick with a clean rag.
Insert the dipstick into the oil fill opening without screwing it
in. Remove the dipstick to check the oil mark.
6. Slowly add more oil and repeat step 4 until the oil mark
reaches to the top of the dipstick. Do not overfill the
crankcase. The generator is equipped with a low-oil sensor
and will not start if the amount of oil is insufficient.
7. Check for oil leaks. Tighten dipstick firmly.
8. Close and latch the left side maintenance cover.
Engine Oil Temperature Recommendations
8
Oil Dipstick