English - IKEA TRADFRI E1810 Manual

English

REMOTE CONTROL FUNCTIONS
ON/OFF: Press to turn your light source on and off.
Press and hold for at least 3 seconds to
synchronize your lights.
Dim up/down: Short presses will dim up/down in
steps. To dim up/down seamlessly, press and hold
the button.
Change white spectrum, colours or scenes.
Pairing: Add IKEA Smart Lighting products to your
system. See instructions below.
ADDING DEVICES TO YOUR REMOTE CONTROL
When the remote control is sold together with a light
source (in the same package), they are already paired.
If the remote control is purchased separately, you must
manually pair it to your light source.
To add light sources, just repeat the steps below.
1. Make sure that your light source is installed and the
main power switch is turned on.
2. Hold the remote control close to the light source
you want to add (no more than 5 cm away).
3. Press and hold the pairing button (1) for at least
10 seconds. A red light will shine steadily on the
remote control. Your light source will begin to dim
and flash one time to indicate that it has been
successfully paired.
Up to 10 light sources can be paired with 1 remote
control.
Make sure to pair them one at a time. If the light
sources are close to each other, disconnect those that
have already been paired from the main power switch.
FACTORY RESET YOUR DEVICES
For light sources:
Toggle the main switch 6 times.
For remote control:
Press the pairing button
SYNCHRONIZING
If your light source becomes unsynchronized, press
and hold the ON/OFF button
to return the light source to its default setting (100%
brightness, 2700K).
CHANGING THE BATTERY
When the remote control is used regularly and as
intended, the batteries will last for approximately 2
years.
When it's time to replace the battery, a red LED
4 times within 5 seconds.
for at least 3 seconds
4