Page 1
SPYDER Electric Pressure Washer Assembly, Care and Use Instructions SPY1500G Read carefully. Retain these instructions and attach receipt to manual for future reference. IMPORTANT: NEVER use an extension cord with this unit. It may cause damage to the motor and VOID the warranty.
Safety Information Please read and understand this entire manual before • DO NOT use your power washer when you are under attempting to assemble, operate, or install the product. the influence of alcohol or drugs. Use this power tool carefully and only when you are alert. This manual contains information that relates to Watch your balance and footing while using your •...
NEVER use lances or other parts that are not • • NEVER leave the power washer “ON” while it is compatible for this specific Powerplay unit. unattended. NEVER spray any electrical outlet with your power • •...
Preparation Before beginning assembly of product, make sure all parts Estimated Assembly Time: 10 minutes are present. Compare parts with package contents list and hardware contents list. If any part is missing or damaged, 855-770-7529 contact customer service at attempt DO NOT to assemble the product.
Page 7
Assembly Instructions Slide foam cannon bracket (K) onto tab on back of power washer unit (D). Slide upper spray gun holder (A) tab into slot on left side of power washer unit (D). From below, slide lower spray gun holder (B) tabs into slots on bottom left side of power washer unit (D).
Page 8
Assembly Instructions Hold back the collar at one end of the end of the hose (G). Push firmly to connect hose fitting to the water outlet tube on the front of the power washer unit (D). Twist the collar clockwise to secure. Confirm hose is locked into the water outlet by slightly pulling on the hose.
Page 9
Assembly Instructions To lock the trigger of the spray gun (H), aim the gun away from you and push the trigger button (I). After doing so, squeeze or pull the trigger to make sure it is locked and will not move. ALWAYS keep spray gun (H) locked when not in use.
Important Initial Startup Release the spray gun safety lock (K) on the spray gun (J). Pull the vari nozzle tip out to the low pressure/ soap position. Point the spray gun in a safe direction and squeeze the trigger until there is a steady stream of water, releasing water and air out of the hose.
Page 11
Operating Instructions Operation Tips Using the Foam Cannon • When using detergent, fill bottle with a properly 1. Detach the lance from the high pressure gun. formulated detergent-to-water ratio, following instructions on the container. • It is normal to hear the motor run intermittently when the trigger is not being squeezed.
Care and Maintenance Cleaning Nozzles Storage A clogged or partially clogged nozzle can cause significant 1. When the pressure washing session is complete, turn reduction of water pressure coming out of the nozzle off the power switch. and/or cause the unit to pulsate while spraying. 2.
Troubleshooting If you have any questions regarding the product, please call customer service at 1-855-770-7529. Problem Corrective Action Unit will not turn on. 1. Make sure the power washer is OFF. Plug the electrical cord into a grounded 120 volt outlet (no electrical extension cord should be used).
Warranty The one year limited consumer warranty of this product is covered by Powerplay Corporation. This product has a 1 (one) year limited consumer warranty. Please read the following carefully to understand what the warranty entails: This product is under warranty to the original retail consumer against defects in material and workmanship for a period 1(one) year.
Replacement Parts 1-855-770-7529. For replacement parts, call our customer service department at 9:00 a.m. - 5:00 p.m., EST, Monday - Friday or order online at www.powerplaypro.com. O-Ring Part Description Part # Part Description Part # Foam Cannon Bracket PWXA095 Caster PWXA105 Foam Cannon PWXA102...
Need help?
Do you have a question about the SPYDER and is the answer not in the manual?
Questions and answers