Related Manuals for PowerXtreme X10
Summary of Contents for PowerXtreme X10
- Page 1 User manual POWERXTREME X10 LiFePO4 Battery EmergoPlus BV Informaticastraat 20 NL 4538 BT Terneuzen Tel. +31 85 20 18 158 www.emergoplus.com info@emergoplus.com...
- Page 2 User manual PowerXtreme X10 Dear customer, Thank you for purchasing the high quality PowerXtreme battery from EmergoPlus! This product has been developed using the most modern technologies and quality systems. We assure you that we make every effort to ensure trouble-free operation so that you are happy with your purchase.
-
Page 3: Table Of Contents
User manual PowerXtreme X10 Table of contents Product description ................4 Safety instructions................. 6 Safety instructions statement ............6 Safety instructions ............... 6 Transport alert ................8 Description and operation ..............9 LiFePO4 battery for caravan mover ..........9 Charging ..................9 PowerXtreme App ............... -
Page 4: Product Description
A lead-acid battery will fail due to sulphating if it is not fully charged for a longer period of time. The PowerXtreme X10 battery consists of 4 cells connected in series with a nominal voltage of 3.2V which together form 12.8V. - Page 5 The PowerXtreme X10 is equipped with Bluetooth technology that allows monitoring of the battery and switching it on and off via an App.
-
Page 6: Safety Instructions
User manual PowerXtreme X10 2. Safety instructions Safety instructions statement The safety instructions help you to avoid hazards when performing actions. The safety instructions are divided into the following categories: WARNING! Means that the act in question is dangerous and should be prepared before proceeding. - Page 7 User manual PowerXtreme X10 contact with the electrolyte, rinse it immediately with plenty of water. After this, consult a doctor. ▪ Use cables of the correct cross-section and keep the cable connections as short as possible. Use reliable cable clamps and tighten the bolts firmly.
-
Page 8: Transport Alert
Transport alert ▪ The Li-ion battery must be transported in its original packaging. ▪ The X10 batteries have been tested according to the UN handbook for tests and criteria, part III, paragraph 38.3 (ST/SG/AC.10/11/Rev.5). During transport, the battery falls under category UN3480 class 9, packing group II and must be transported in accordance with these regulations. -
Page 9: Description And Operation
User manual PowerXtreme X10 3. Description and Operation 3.1 LiFePO4 battery for caravan mover The battery has more than enough capacity to carry out 2 normal displacement operations of a caravan. With heavy use (35 A continuous) you can use the mover for up to 30 minutes. With extreme use (100 A) you can use the mover for approx. -
Page 10: Powerxtreme App
Google Play store (suitable for Android 4.3 or higher) you can download the PowerXtreme App and use it to read the status and health of your battery. When you open the APP a dialog box appears where you can see all Bluetooth devices within the range (<... - Page 11 User manual PowerXtreme X10 SOC means "State of Charge" or the state of charge of the battery. The voltage and capacity of the battery are listed below. STATUS" shows whether the battery is charging or discharging or whether the battery is in standby mode.
- Page 12 User manual PowerXtreme X10 The UITC info shows 2 "meters", on the left the battery voltage and on the right the current. This can be the charging current or the current drawn from the battery. If the battery is connected to a charger but at the same time power is requested by users, the resulting current is displayed.
-
Page 13: Powerxcharger Xc3 (Option)
To charge the battery while driving, the PowerXCharger XC3 is available as an option. This converts the charging voltage of the car alternator into the right charging voltage for the PowerXtreme battery. Due to the limited charging current, there is no need to install thick wiring. The XC3 also acts as a battery guard. - Page 14 Battery Battery terminals + and – Mounting plate with Velcro and 4 self-tapping screws Battery charger Instruction card Figure 1. Package contents X10 After unpacking, check all parts for possible damage. ▪ Fully charge the battery before first use. ▪...
- Page 15 User manual PowerXtreme X10 PAY ATTENTION! meegeleverde accupolen hebben verschillende diameters, de dunste is voor de negatieve pool, de dikste voor de positieve pool. Figure 2. Difference diameter of + and - pole Switch off all loads and charging equipment before you start ▪...
- Page 16 User manual PowerXtreme X10 Figure 3. WRONG! Loose connection by using too long bolt Connect the negative pole of the battery to the negative connection ▪ of the caravan mover unit. Connects the positive terminal of the battery to the positive ▪...
- Page 17 User manual PowerXtreme X10 PAY ATTENTION! Install a fuse and a main switch to the power circuit according local regulations. Place the fuse as close as possible to the + pole of the battery. After first use or test all connections for (over) heating. Repair or ▪...
-
Page 18: Decommissioning
User manual PowerXtreme X10 4. Decommissioning Electric appliances should not be disposed of with normal household waste. According to the European Directive 2012/19/EU on waste electrical and electronic equipment (WEEE), these devices must be collected separately in order to recycle them in an environmentally friendly manner possible. -
Page 19: Technical Specifications
User manual PowerXtreme X10 5. Technical specifications Battery Model Cell Chemistry LiFePO4 Voltage Nominal Voltage 12,8V Capacity 10Ah Max. continuous power 100A Short-term power (30 Sec) 150A Peak power (1 sec) 200A Max. charging power Max. charging voltage 14,6V Max. discharge voltage DC charge input max. -
Page 20: Charger
User manual PowerXtreme X10 Charger Model Input Voltage 100 – 240 VAC Input Frequency 50 – 60 Hz Output voltage 14,6 V Charging current Charging characteristic CC - CV Dimensions 110 x 62 x 34 mm www.emergoplus.com E18-X10-EN00 Page 20 of 24... -
Page 21: Faults And Repairs
User manual PowerXtreme X10 6. Faults and repairs 6.1 Fault finding table Problem Cause Solution Reconnect the Possible charger Charger LED flashes charger. Replacing the defective or charging charger will result in a circuit failure malfunction. Check charging current (2A) with APP. -
Page 22: Warranty Conditions
User manual PowerXtreme X10 7. Warranty conditions EmergoPlus guarantees that the PowerXtreme X10 is built according to the legally applicable standards and provisions. All PowerXtreme X10 has been extensively tested and checked during production and before delivery. Failure to act in accordance with the instructions and provisions of this manual may result in damage and / or the unit will not meet our specifications. -
Page 23: Eg Declaration Of Conformity
User manual PowerXtreme X10 9. EG Declaration of Conformity EG DECLARATION OF CONFORMITY OF ELECTRICAL EQUIPMENT Declaration according to Directive 2014/35 / EC, as amended This language version of the statement is checked by the manufacturer (original statement). Name EmergoPlus BV... - Page 24 User manual PowerXtreme X10 EN60950- Information technology equipment - Safety - Part 1: General requirements 1:2005+A1:2009+A2:2013 and which the following natural or legal person established in the Community is authorized to compile the technical file: Name EmergoPlus BV Name and position...
Need help?
Do you have a question about the X10 and is the answer not in the manual?
Questions and answers