Setting Up The Poe-X Low Temperature Sensor; The Lighting Sequence - Monnit PoE-X Low Temperature Sensor User Manual

V. SETTING UP YOUR PoE-X SENSOR
Plug in powered Ethernet cable.
Depending on your facility, you might need
to plug in both the Ethernet cable and power
cord. See Figure 3.
LIGHTING SEQUENCE
The sensor will cycle through three stages as it powers on:
Power-on stage: At this stage, the sensor will analyze electronics and
programming. The LED lights will flash red and green, before all becoming green
for one second. In the case of failure, the light sequence will repeat after ten
seconds. Please contact technical support if the lights aren? t green after two
minutes.
Connection stage: The sensor will attempt to settle all operational connections.
As the sensor attempts to connect, the Sensor Status LED will be off, waiting for
the Ethernet connection to complete. After the Ethernet setup is complete, the
Sensor Status Light will briefly blink red before turning green and then going off
completely. If the Ethernet Status LED is orange, there is a failure in your
Ethernet connection. Check your connection.
Operational stage: In the operational stage, the Ethernet lights will remain
active while the Sensor Status light remains off ? unless there is an issue. See
Figure 4 & Figure 5.
PAGE 4
Ethernet Status LED
Steady Blinking Green:
Performing Ethernet set up
operations
Solid Green with Flicker:
Connection successful for normal
operation
Ethernet Link LED
Off:
No Ethernet cable connected
Green:
Ethernet is connected
Figure 3
Figure 4