How To Configure Standby Timer For All Disk Drives - AIC JBOD Series User Manual
12gb/s sas
Hide thumbs
Also See for JBOD Series:
- User manual (96 pages) ,
- User manual (122 pages) ,
- User manual (105 pages)
Table of Contents
Advertisement
J2024-02 User Manual
3.5.6 How to configure standby timer for all disk drives
This feature is applicable for SAS/SATA drives. Standby timer is in units of minutes.
Setting standby timer with 0 minute disables this feature.
(A) Get current standby timer
cmd> standby_timer
Standby Timer : 0 minutes
(B) Set the standby timer with 10 minutes. The new setting will take effect after reset.
cmd> standby_timer 10
cmd> reset
NOTE
This function is not recommended to use with RAID card due to RAID card limitation.
Chapter 3 Sub-system Configuration Setup
32
Advertisement
Table of Contents
Need help?
Do you have a question about the JBOD Series and is the answer not in the manual?
Questions and answers