Related Manuals for Kenco KL9000
Summary of Contents for Kenco KL9000
- Page 1 Attachment Solutions KL9000 BARRIER LIFT KL9K6T12V4 Concrete median barrier handling device Operators Manual Conforms to ASME B 30.20, BTH-1 Design Category B, Service Class 3...
-
Page 2: Table Of Contents
TABLE OF CONTENTS Section I. General Information...................... 1 Section II. Safety ..........................1 Section III. Identification of Major Components ................3 Section IV. Setup..........................3 Section V. Operation........................5 Section VI. Maintenance ........................7 Section VII. Inspection Criteria ......................8 Section VIII. -
Page 3: General Information
Section I. General Information ® May we take this opportunity to thank you for purchasing the KENCO Kenlift ® highway median barrier wall handling system. The Kenlift System provides the ultimate in ® below the hook concrete highway barrier handling versatility. The Kenlift is quality engineered to provide years of trouble free, low maintenance performance. - Page 4 170 State Route 271 Ligonier, PA 15658 1-800-653-6069 2. Do not wear loose clothing, jewelry, or hairstyles that could become entangled in the KENCO ® Kenlift or rigging hardware. 3. Keep hands, feet, and any other appendages clear of Kenlift® while in operation.
-
Page 5: Identification Of Major Components
1. Use as few rigging components (shackles, slings, chain, etc.) as possible. 2. ALL RIGGING COMPONENTS MUST HAVE A WORKING LOAD LIMIT THAT IS EQUAL TO OR GREATER THAN THE COMBINED WEIGHT OF INTENDED ® LOAD PLUS THE Kenlift ® KENCO Kenlift Operation Manual... - Page 6 4. DO NOT RIG UNPROTECTED NYLON SLINGS OR WIRE ROPE DIRECTLY THROUGH LIFT BAIL. 5. IF USING EQUIPMENT OTHER THAN A CRANE: USE RIGGING OF SUFFICIENT ® LENGTH TO PREVENT CONTACT BETWEEN Kenlift AND EQUIPMENT. ® KENCO Kenlift Operation Manual...
-
Page 7: Operation
8. Deposit at desired location. ® 9. Release tension on lift cable. (Note: avoid undue slamming of the Kenlift into open position to prolong actuator life.) ® ® 10. Remove Kenlift (Kenlift is latched in open position automatically) ® KENCO Kenlift Operation Manual... - Page 8 DANGER proportional to and dependent on the weight of the barrier wall. It is for this reason that while in operation the Kenlift and wall NEVER be allowed to contact other items. ® KENCO Kenlift Operation Manual...
-
Page 9: Maintenance
2. Inspect holes, pins, bolts etc. for wear. See sect VII for criteria. 3. Remove actuator, clean and lubricate with light penetrating oil – check for signs of wear, replace if necessary. * Frequency depends on usage, environmental conditions, etc. ® KENCO Kenlift Operation Manual... -
Page 10: Inspection Criteria
Any scarring, chunking, or missing pad material constituting a total combined loss of surface area greater than 3 sq. in. per pad. d. Any single scar, chunk, or missing pad face that is greater than 1 sq. in per pad. ® KENCO Kenlift Operation Manual... -
Page 11: Parts/Drawings
Section VIII. Parts/Drawings ® KENCO Kenlift Operation Manual... - Page 12 170 State Route 271 Ligonier, PA 15658 1-800-653-6069 ® KENCO Kenlift Operation Manual...
- Page 13 CROSS SECTIONAL DESIGNATIONS ® KENCO Kenlift Operation Manual...
- Page 14 170 State Route 271 Ligonier, PA 15658 1-800-653-6069 ® KENCO Kenlift Operation Manual...
- Page 15 DANGER DO NOT STAND UNDER OR NEAR WHILE MACHINE IS OPERATING KENCO CORPORATION 877-4ATTACH WARNING MODEL Read and understand operator’s manual before USAGE using this equipment. Failure to follow operating CAPACITY and maintenance procedures could result in death or serious injury.
- Page 16 1.00 X 5 BOLT .3125 X 1.5 BOLT 1.00 NUT 1.00 FLAT WASHER .3125 NUT .3125 STAR INTERNAL .5 LOCK WASHER .5 NUT DANGER STICKER IDTAG BTH TAG LG. WARNING STICKER SM. WARNING STICKER ID STICKER ® KENCO Kenlift Operation Manual...
-
Page 17: Available Options
Section IX. Available Options A. Alignment legs 1. Kenco provides an optional bolt-on attachment that facilitates hands off operation when used on the automatic model. ® 2. The Kenlift with alignment leg attachment is simply guided by the hoist operator into ®... -
Page 18: Warranty
1. KENCO Corporation (KENCO) warrants the KENCO Kenlift lifting device (not including pads or consumable items) sold by KENCO to be free from proven defects in material and workmanship for a period of six (6) months from the delivery date to the original customer.
Need help?
Do you have a question about the KL9000 and is the answer not in the manual?
Questions and answers