Sony ZRD-1 Operating Instructions Manual page 16

Note
You can view information on a display controller by
double-clicking its controller number or by right-
clicking it and selecting [Controller Info.].
[Array Information]
Displays the status of each display unit.
(gray): The display unit is turned on.
(black): The display unit is turned off.
(maroon): An error has occurred on the display unit.
(ocher): A warning has occurred on the display unit.
(black): A display unit does not exist.
Note
You can view information on a display unit by double-
clicking within its frame or by right-clicking it and
selecting [Display Unit Info.].
If the controller PC is slow
By suspending the connection to the display controllers,
you can avoid slow communication responses that may
occur when using other applications, for example.
Select [Disconnect] in the [System] menu on the main
screen of Display Control Software to suspend
communication with the display controllers.
The following dialog box is displayed while
communication is suspended.
To reestablish connection
Close the dialog box.
Entering the forced standby mode
If the controller PC hangs, for example, you can force
display controllers and display units into standby mode.
1
Press and hold the power switch on the display
controller for at least 5 seconds.
The forced standby mode is entered, and the POWER
indicator lights red.
2
Press and hold the power switch again for about
2 seconds.
After the POWER indicator blinks red/orange, the
normal standby mode is entered.
The display units will also enter the normal standby
mode.
16