Philips 5000 Series Manual page 43

1
3
2
3 Place the shaver in the holder (1), tilt the shaver
backwards (2) and press down the top cap to
connect the shaver ('click') (3).
The battery symbol starts to ash, which
indicates that the shaver is charging.
4 Press the on/o button on the SmartClean
system to start the cleaning program.
During the rinsing phase, the rinsing symbol
ashes. When the rinsing phase is done (after
approx. 10 minutes), the rinsing symbol lights up
continuously.
When the cleaning program is done, the ready
symbol lights up continuously.
30 minutes after the cleaning program and
charging are done, the SmartClean system
switches o automatically.
The battery symbol lights up continuously to
indicate that the shaver is fully charged.
Charging takes approx. 1 hour.
5 To let the shaver dry, you can leave it in the
SmartClean system until your next shave. You
can also remove the shaver from the
SmartClean system, shake o excess water,
open the shaving unit and let the shaver air dry.
Note: If you press the on/o button of the
SmartClean system during the cleaning program,
the program aborts. In this case, the rinsing or
drying symbol goes out.
Note: If you remove the supply unit from the wall
socket during the cleaning program, the program
aborts.
42
21
English
English