Trouble Shooting - Panasonic VW-BN2 Operating Instructions Manual

¬ Trouble shooting
Problem
This unit cannot be
turned on.
This unit cannot be
operated even when
powered up.
This unit does not
operate normally.
[<]
The button does not
work.
The disc cannot be read.
Copying stops.
The playback picture
breaks up for a moment.
Cannot copy although
power is supplied to this
unit and the disc is
correctly inserted.
16
LSQT1572
≥ Is the AC adaptor connected?
> Connect the AC adaptor and the
(P11)
≥ Disconnect the AC adaptor and then about 1 minute later
connect it again. (Conducting the above operation when the
access lamp is on may destroy the data on the disc.) If normal
conditions are not restored, detach from the connected power
source and consult the dealer who you purchased this unit from.
≥ The disc will not eject unless this unit is powered.
> Connect the AC adaptor.
≥ The [<] button may not work when copying from a connected
video camera to a disc is in progress.
> Wait until the copying is finished.
≥ In cases other than the above, detach from the connected
power source and consult the dealer who you purchased this
unit from.
≥ Is the disc scratched or dirty?
> Wipe off the dirt on the disc. (P9) If the disc is scratched,
insert a new one.
≥ The internal temperature of this unit is high. Disconnect the AC
adaptor, wait a short while and then you will be able to use this
unit again.
≥ Discs recorded on other devices may not be correctly read or
played back on this device.
≥ Has the disc already been used for recording video and still
pictures?
> If the disc contains recorded material, it cannot be used
again. Use a new disc.
> DVD-RAM, DVD-RW, +RW or CD-RW discs recorded with
any material can be reused after formatting the disc. Since all
data previously recorded on the disc will be deleted, confirm
contents of the disc carefully before reformatting it.
Check points
AC mains lead
correctly.