Pushing The Machine By Hand - Toro 72201 Operator's Manual

Engaging the Cruise Control
1. Begin driving tractor: Refer to Driving Forward or
Backward, page 19. While holding your foot steady on
the traction control, push the cruise control switch
(Fig. 18) to the lock–set position.
Figure 18
1. Lock–Set
2. This locks the traction control in position and your
foot can then be removed from the traction control.
A constant ground speed will be maintained.
Disengaging the Cruise Control
1. While holding your foot steady on the traction control,
move the cruise control switch (Fig. 18) to the
unlock–off position.
2. This unlocks the traction control and your foot then
operates the traction control.
3. For quick stops, just press on the brake pedal. This
automatically disengages the cruise control and applies
the brake at the same time.

Pushing the Machine by Hand

Important
Always push the machine by hand. Never
tow the machine because transaxle damage may occur.
To Push the Machine
1. Disengage the power take off (PTO) and turn the
ignition key to off.
2. Move the drive control rod to the push position. This
disengages the drive system and allows the wheels to
turn freely (Fig. 19).
To Operate the Machine
1. Move the drive control rod to the operate position
(Fig. 19).
Note: The machine will not drive unless the drive control
rod is in the operate position.
1
2
1238
2. Unlock–Off
22
1
2
Figure 19
1. Operate position
2. Push position
3
M–4566
3. Drive control rod