Stopping The Engine; Using The Safety Interlock System - Toro 71199 Operator's Manual

Hide thumbs Also See for 71199:
Table of Contents

Advertisement

4. Shift the blade control (PTO) lever to Disengage
(Fig. 5).
5. Shift the throttle lever to Choke (Fig. 8).
Figure 8
1. Choke
2. Fast
Note: An engine that has been running and is warm
may not require step 5.
6. Turn the ignition key clockwise and hold it in the Start
position (Fig. 9). When the engine starts, release the
key.
Figure 9
1. Start
2. On
Important
If the engine does not start after 30 seconds
of continuous cranking, turn the ignition key to Off and let
the starter motor cool; refer to Troubleshooting on page 38.
7. After the engine starts, slowly shift the throttle lever to
Fast (Fig. 8). If the engine stalls or hesitates, shift the
throttle lever back to Choke for a few seconds and then
shift the throttle lever to Fast. Repeat this step as
required.
1
2
3
4
m-1859
3. Slow
4. Throttle lever
3
2
1
3. Off
15

Stopping the Engine

1. Shift the throttle lever to Slow (Fig. 8).
2. Turn the ignition key to Off (Fig. 9).
3. Remove the ignition key.
Using the Safety Interlock
System
Caution
If the safety interlock switches are disconnected or
damaged, the tractor could operate unexpectedly,
causing personal injury.
Do not tamper with the interlock switches.
Check the operation of the interlock switches
daily and replace any damaged switches before
operating the tractor.
Replace switches every 2 years regardless of
whether they are operating properly or not.
Understanding the Safety Interlock
System
The safety interlock system is designed to prevent the
engine from starting unless:
The clutch/brake pedal is depressed.
The blade control (PTO) lever is in the Disengage
position.
The safety interlock system stops the engine if you rise
from the seat when you release the clutch/brake pedal or
engage the blade.
Setting the KeyChoice Switch to
Operate in Reverse
The interlock feature on the tractor prevents the power
take-off (PTO) from operating when you back up the
tractor. If you shift the ground speed lever into Reverse
with the PTO engaged (i.e., with the mower blades or other
attachment running), the engine will stop. Do not mow in
reverse unless it is absolutely necessary.
If you need to use the PTO while backing up, turn off the
interlock feature using the KeyChoice switch located near
the seat bracket (Fig. 10).

Advertisement

Table of Contents
loading

This manual is also suitable for:

12-32xl wheel horse

Table of Contents